Sony DSC-T1 Service Manual ▷ View online
DSC-T1
— 6 —
Sony EMCS Co.
2007B1600-1
©2007.02
Published by Kohda TEC.
9-876-280-41
— 4 —
DSC-T1
SERVICE NOTE
SELF-DIAGNOSIS FUNCTION
• NOTE FOR REPAIR
• NOTE FOR REPAIR
[Discharging of the FLASH unit’s charging capacitor]
The charging capacitor of the FLASH unit is charged up to the
maximum 300 V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand. The electric shock is caused by the
charged voltage which is kept without discharging when the main
power of the DSC-T1 is simply turned off. Therefore, the remaining
voltage must be discharged as described below.
maximum 300 V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand. The electric shock is caused by the
charged voltage which is kept without discharging when the main
power of the DSC-T1 is simply turned off. Therefore, the remaining
voltage must be discharged as described below.
Preparing the Short Jig
To preparing the short jig. a small clip is attached to each end of a
resistor of 1 k
To preparing the short jig. a small clip is attached to each end of a
resistor of 1 k
Ω /1 W (1-215-869-11)
Wrap insulating tape fully around the leads of the resistor to prevent
electrical shock.
electrical shock.
1 k
Ω/1 W
Wrap insulating tape.
Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
Cut and remove the part of gilt
which comes off at the point.
(Take care that there are
some pieces of gilt left inside)
which comes off at the point.
(Take care that there are
some pieces of gilt left inside)
When remove a connector, don't pull at wire of connector.
Be in danger of the snapping of a wire.
Be in danger of the snapping of a wire.
When installing a connector, don't press down at wire of connector.
Be in danger of the snapping of a wire.
Be in danger of the snapping of a wire.
Discharging the Capacitor
Short circuits between the positive and the negative terminals of
charged capacitor with the short jig about 10 seconds.
Short circuits between the positive and the negative terminals of
charged capacitor with the short jig about 10 seconds.
Capacitor
ST-86 BOARD
Shorting jig
(1k
(1k
Ω
/ 1w)
Sony EMCS Co.
SERVICE MANUAL
SUPPLEMENT-1
File this supplement-1 with the service manual.
(PV03-016)
LEVEL
1
DSC-T1
US Model
Canadian Model
AEP Model
UK Model
E Model
Hong Kong Model
Australian Model
Korea Model
Chinese Model
Tourist Model
Japanese Model
2004C1600-1
©2004.3
Published by DI CS Strategy Div.
9-876-280-82
Ver 1.1 2004.03
• Addition of Black Model.
: Added portion.
Page
3
Before change
Checking supplied accessories.
After change
UC-TA USB cradle (1)
1-817-742-11
1-817-742-11
Wrist strap (1)
3-086-283-01
3-086-283-01
UC-TA USB cradle (1)
1-817-742-11 (SILVER)
1-817-742-21 (BLACK)
1-817-742-11 (SILVER)
1-817-742-21 (BLACK)
Wrist strap (1)
3-086-283-01 (SILVER)
3-086-283-11 (BLACK)
3-086-283-01 (SILVER)
3-086-283-11 (BLACK)
Sony EMCS Co.
SERVICE MANUAL
SUPPLEMENT-2
File this supplement-2 with the service manual.
(PV03-018)
LEVEL
1
DSC-T1
US Model
Canadian Model
AEP Model
UK Model
E Model
Hong Kong Model
Australian Model
Korea Model
Chinese Model
Tourist Model
Japanese Model
2004C1600-1
©2004.3
Published by DI CS Strategy Div.
9-876-280-85
Ver 1.2 2004.03
• Change of parts number.
• Addition of Accessory.
• Addition of Accessory.
: Changed portion.
: Added portion.
Page
3
Before change
Checking supplied accessories.
After change
CD-ROM
(USB Driver SPVD-013) (1)
(AEP, UK, E, HK, AUS, CH,
JE, KR model)
3-087-330-01
CD-ROM
(USB Driver SPVD-013 (I)) (1)
(US, CND, J model)
3-087-331-01
(USB Driver SPVD-013) (1)
(AEP, UK, E, HK, AUS, CH,
JE, KR model)
3-087-330-01
CD-ROM
(USB Driver SPVD-013 (I)) (1)
(US, CND, J model)
3-087-331-01
CD-ROM
(USB Driver SPVD-013) (1)
(AEP, UK, E, HK, AUS, CH,
JE, KR model)
3-087-330-11
CD-ROM
(USB Driver SPVD-013 (I)) (1)
(US, CND, J model)
3-087-331-11
(USB Driver SPVD-013) (1)
(AEP, UK, E, HK, AUS, CH,
JE, KR model)
3-087-330-11
CD-ROM
(USB Driver SPVD-013 (I)) (1)
(US, CND, J model)
3-087-331-11
UPDATE CD-ROM (PB), T1
3-091-965-01
3-091-965-01
Click on the first or last page to see other DSC-T1 service manuals if exist.