Sony MEX-1HD Service Manual ▷ View online
17
MEX-1HD
3-13. TRAY (UD) ASSY
3-14. OP ASSY (CDM-3021EBG)
3
screw (M1.7
×
2.5)
4
5
tray (UD) assy
3
three screws (M1.7
×
2.5)
3
screw (M1.7
×
2.5)
1
Rotate the gear (5) in the direction
of arrow
of arrow
A
to release the mecha-lock.
A
B
2
Draw out the tray block
(D) assy fully in the
direction of arrow
(D) assy fully in the
direction of arrow
B
.
6
insulator
6
insulator
1
saranet cushion
positioning
dowels
dowels
positioning
dowels
dowels
2
two connectors (CN2, CN3)
4
adhesive sheet (MD)
3
5
base flexible board (CN1)
base flexible board
Note: To install the base flexible board,
fix it along the dowels on the tray.
Note: Do not reuse the adhesive sheet (MD)
after removing the OP assy (CDM-3021EBG).
Be sure to replace a brand-new adhesive sheet (MD).
Be sure to replace a brand-new adhesive sheet (MD).
6
insulator
7
OP assy (CDM-3021EBG)
Ver 1.1
18
MEX-1HD
3-15. SERVO BOARD
4
three screws (M2
×
3.5)
7
servo board
5
6
motor flexible board (CN5)
1
Bend the claw.
2
D20P flexible board (CN6)
3
D40P flexible board (CN7)
1
Bend the claw.
Ver 1.1
19
MEX-1HD
SECTION 4
ASSEMBLY
4-1.
ASSEMBLY FLOW
• This set can be assembled in the order shown below.
Note:
Follow the assembly procedure in the numerical order given.
4-2.
MOTOR BLOCK ASSY
Ver 1.1
4-2. MOTOR BLOCK ASSY
(Page 19)
4-3. CAM BLOCK ASSY
(Page 20)
4-4. PHASE ALIGNMENT OF
MOTOR BLOCK ASSY AND
CAM BLOCK ASSY
(Page 20)
CAM BLOCK ASSY
(Page 20)
3
two screws (PTT2.6
×
6)
2
bracket (sub, L) assy
1
Align the gear (cam L) position setting hole with
the center mark on the bracket (main L) assy.
bracket (main L) assy
center mark
20
MEX-1HD
Ver 1.1
4-3.
CAM BLOCK ASSY
4-4.
PHASE ALIGNMENT OF MOTOR BLOCK ASSY AND CAM BLOCK ASSY
1
Align the gear (cam R) position setting hole with
the center mark on the bracket (main R) assy.
bracket (main R) assy
center marking
5
screw (PTT2.6
×
6)
2
motor block assy
6
cam block assy
7
two screws (PTT2.6
×
6)
gear (cam R)
1
connector (CN411)
3
screw (PTT2.6
×
6)
4
cover (protection)
Note : Touch the gear (cam R) with fingers in the
direction of rotation and make sure that
there is no phase difference with the motor
block assy side position setting hole.
there is no phase difference with the motor
block assy side position setting hole.
Click on the first or last page to see other MEX-1HD service manuals if exist.