Sony ZS-BTY50 / ZS-BTY52 / ZS-BTY55 Service Manual ▷ View online
ZS-BTY50/BTY52/BTY55
25
2-28. POWER BOARD
35 to 40 mm
Note 2: In reassembling, use new binding
band (taiton) to fasten the clamp
same as before.
Note 1: Roll the wire 3 times.
:LUHVHWWLQJ
)HUULWHFRUH)&VHWWLQJ
3 Cut the binding band (taiton).
1 tape (sub material)
4 Remove four solders.
4 Remove two solders.
5 power transformer
(T951)
6 POWER board
POWER board
2 ferrite core (FC1)
ferrite core (FC1)
tape (sub material)
POWER board
%7<%7<
%7<
binding band (taiton)
POWER board
POWER board
binding band (taiton)
ZS-BTY50/BTY52/BTY55
26
2-29. INLET BOARD
3 two tapping screws
(BV
B2.6)
A
A
3 tapping screw
(BV
B2.6)
5 two tapping screws
(BV
B2.6)
7 cushion
(inlet
C)
6 holder (inlet) block
1 connector
(CN963)
2 connector
(CN962)
POWER board
INLET board
(BTY50/BTY52)
:LUHVHWWLQJ
CN963
8 INLET board
4 Remove the INLET board block
in the direction of an arrow.
Note: Please make wire of CN963 into a near side.
ZS-BTY50/BTY52/BTY55
27
1 two tapping screws
(BV
B2.6)
1 two tapping screws
(BV
B2.6)
1 two tapping screws
(BV
B2.6)
2 joint (Rch)
– Rear side view –
2-30. JOINT (Rch)
2-31. LOUDSPEAKER (10.2 cm) (Rch) (SP2)
2 four tapping screws
(BV
B3)
3 Remove the loudspeaker (10.2 cm)
block in the direction of an arrow.
5 loudspeaker (10.2 cm) (Rch)
(SP2)
[black]
[red]
“
−” terminal
“
+” terminal
1 Remove two solders.
4 cushion (A wire)
– Rear side view –
6SeaNer wire seWWiQJ
Note: When installing the sloudspeaker
(10.2 cm) (Rch) (SP2), check that
terminal position is bottom side.
terminal position is bottom side.
ZS-BTY50/BTY52/BTY55
28
4 Remove the box (L) block
in the direction of an arrow.
6 box (L) block
5 Pull out wires.
3 four tapping screws
(BV
B2.6)
– Rear side view –
1 two tapping screws
(BV
B2.6)
2 box lid (Lch) block
– Bottom side view –
OK
NG
cushion
Cushion is sticking out a lot.
Cushion is not fitted in the ditch.
0.5 ± 1 mm
:ire settiQJ
2-32. BOX (L) BLOCK
Click on the first or last page to see other ZS-BTY50 / ZS-BTY52 / ZS-BTY55 service manuals if exist.