DOWNLOAD Sony TAV-L1 Service Manual ↓ Size: 20.25 MB | Pages: 127 in PDF or view online for FREE

9

MAIN board

10

Connect the extension jig (J-2501-288-A) to the
SUB board (CN918) and CONNECT board (CN1301).

Connect the extension jig (J-2501-287-A) to the
SUB board (CN909) and CONNECT board (CN1305).

SUB board (CN918)

SUB board (CN909)

SUB board

CONNECT board
(CN1305)

CN1301

CN1305

CONNECT board
(CN1301)

DVD block

belt

CONNECT board

A

Note: Rotate the belt in the arrow 

A

 direction until 

the CONNECT board can be seen 
best to lower the DVD block.

Note: Though the connector for jig connection 

is located where it may hard to make 
an access to it as shown below, 
perform work in this state.

11

Note2: Note when installing the driving block joint section

When installing the driving block joint section, beware of the bracket (plate screw) front surface.

Note1: If the driving block joint section is moved up or down, it can swing in all directions.

When moving the driving block joint section up or down, 
protect the LCD front surface with protective materials 
such as a cardboard so as not to damage the LCD front surface.

LCD

driving block

protective material

bracket (plate screw)

Note: When the driving block joint section is lowered, rotate the 

A

 in the arrow direction 

so that the driving block joint section comes to the position higher than the sensor 
(to the extent that the belt is removed).

driving block

A

sensor

belt

12

KHM-310CAB

XXXXXXXX

XXXXXXXXX

Printed of KHM-310CAB or KHM-313CAB.

Note: There are two kinds of OPTICAL PICK-UP BLOCK in this set.

When replacing the OPTICAL PICK-UP BLOCK, make sure which 
OPTICAL PICK-UP BLOCK it is following the “How to Identify” 
in the figure shown below.

DVD mechanism deck
(CDM86-DVBU101)

lead screw

Note: When replacing and checking the lead screw, 

apply the part No.7-640-014-49 GREASE (SNG-511) 20G 
to the entire lead screw.