Sony ICD-SX46 / ICD-SX56 / ICD-SX66 Service Manual ▷ View online
5
ICD-SX46/SX56/SX66
Note:
Follow the disassembly procedure in the numerical order given.
2-2. COVER (JACK)
SECTION 2
DISASSEMBLY
2-1. DISASSEMBLY FLOW
Note:
Disassemble the unit in the order as shown below.
2-3.CASE BLOCK ASSY
(Page 6)
2-4.AUDIO BOARD,
MICROPHONE UNIT(MIC2/3)
(Page 6)
2-5.ORNAMENT BELT ASSY,
SW BOARD
(Page 7)
2-6.COVER (CHASSIS)
BLOCK ASSY
(Page 7)
2-7.MAIN BOARD,
LIQUID CRYSTAL DISPLAY
PANEL (Page 8)
2-2.COVER (JACK)
(Page 5)
SET
4
screw
6
screw
5
cover (jack)
3
lid (connecter)
2
screw (M1.4)
1
battery lid
6
ICD-SX46/SX56/SX66
2-3. CASE BLOCK ASSY
2-4. AUDIO BOARD, MICROPHONE UNIT (MIC2/3)
Pass the flexible board through
the hole during assembling.
the hole during assembling.
3
Slide the chassis from the case completely and remove it.
1
Slide the chassis from the case until the connector becomes visible.
2
connector
11pin (CN7005)
9
Remove the microphone unit (MIC2/3)
from the groove.
8
cushion
6
Remove soldering at two positions of the speaker cable.
2
1
connector
40pin (CN7003)
4
LCD holder
5
liquid crystal
display panel
3
three claws
7
connector
4pin (CN3001)
q;
AUDIO board
7
ICD-SX46/SX56/SX66
2-5. ORNAMENT BELT ASSY, SW BOARD
2-6. COVER (CHASSIS) BLOCK ASSY
6
SW board
2
knob (HOLD)
1
peel off the three
adherent areas
3
ornamental belt assy
4
six claws
6
ornamental
belt
5
three
sheets
(ornamental belt)
1
claw
1
claw
1
claw
1
claw
2
cover (CHASSIS)
3
speaker (1.6cm)
SP3001
chassis block assy
8
ICD-SX46/SX56/SX66
2-7. MAIN BOARD, LIQUID CRYSTAL DISPLAY PANEL
2
1
Remove the two battery terminals
from the groove of the chassis.
chassis block assy
8
MAIN board
5
battery (–) terminal
4
battery (+) terminal
3
Remove soldering from the two points.
7
liquid crystal
display panel
6
sheet, insulating
Click on the first or last page to see other ICD-SX46 / ICD-SX56 / ICD-SX66 service manuals if exist.