Sony DAV-SZ1000W / HBD-SZ1000W (serv.man2) Service Manual ▷ View online
1. When USB device is connected, it is detected at the VBUS_OC
terminal of the MTK IC(IC1101 197pin).
2. When it is set to USB mode, the digital audio signal from the USB
terminal is input to the MTK IC(IC1101).
p
(
)
3. The MTK IC decodes the USB signal and outputs the signal to the
AMP circuit in a same manner as disc playback signal output. (See 4-
1)
1)
4. The musical signal taken in at the MTK IC(See 3-2) will be output to
the USB device from the USB_DM terminal and USB_DP terminal of
the MTK IC(IC1101 44-45pin) For this operation only MP3files can be
the MTK IC(IC1101 44-45pin) For this operation only MP3files can be
the MTK IC(IC1101 44-45pin). For this operation only MP3files can be
transferred to USB device.
transferred to USB device.
29
Page
Following are the key excerpts from the Troubleshooting described in the
Instruction Manual.
Instruction Manual.
30
Page
1. The power is not turned on.
1. Make sure the AC power code is connected properly.
2. When connecting the AC power code into an outlet for the first time, the unit
automatically enters to STANDBY mode Check the unit at this stage “DMEO”
automatically enters to STANDBY mode. Check the unit at this stage, DMEO
indication is shown on the display. If the unit dose not work, firstly check the
status of the SYSTEM CONTROLLER(IC5002) to boot up, for voltage and clock
generation and such.
indication is shown on the display. If the unit dose not work, firstly check the
status of the SYSTEM CONTROLLER(IC5002) to boot up, for voltage and clock
generation and such.
3. Check if the VDR901 is not cut.
2. The System dose not work normally
1. Pull out the AC power code form the outlet and then reconnect after several
minutes.
2. Perform the following steps to reset.
1. Press the power button to turn it on.
2. Press “PLAY”, “FUNCTION”, and POWER button at same time. “RESET”
appears in the front panel display.
(Note)
•
When resetting, the [MEDIA], [INTERVAL], and [EFFECT] configuration setting
i iti li
d
31
are initialized.
Page
1. There is no picture
1. Check if the video input of the TV is not set for other input purpose.
2. Check the output method of the unit.
2. There is no picture when you make an HDMI cable connection.
1. The unit may be connected to an input device which does not support
HDCP(High-bandwidth Digital Content Protection). In this case, “HDMI” indication
on the front panel dose not light up.
on the front panel dose not light up.
2 Change the setting as described on page 63 in the Instruction Manual Connect
2. Change the setting as described on page 63 in the Instruction Manual. Connect
the unit to TV by an analog cable so that you can see the screen for the setting
on the display.
on the display.
32
Page
Click on the first or last page to see other DAV-SZ1000W / HBD-SZ1000W (serv.man2) service manuals if exist.