Sony CMT-V50IP Service Manual ▷ View online
CMT-V50iP
9
2-4. CASE (DOCK TOP)
2-3. DOCK BLOCK
1
two screws
(BTTP
M2.6)
2
two claws
two shafts
shaft
shaft
two ditches
two ditches
– Panel (bottom) block rear side view –
3
dock block
Note: When installing the dock block,
make the position of four ditches
match four shafts.
1
Move the spring (loading) to the position of a figure with a screwdriver etc.
Note
1: Return the position of the spring (loading) after attaching the case (dock top).
spring (loading)
spring (loading)
hook
screwdriver etc.
– Dock block rear side view –
2
two screws
(BVTP2.6)
3
case (dock top)
2
two screws
(BVTP2.6)
Note 3: When installing the case (dock top), match the center
of the lever (cam) with the position of a mark.
Note 2: When installing the case (dock top), check that
the spring (loading) is in the position of a figure.
CMT-V50iP
10
2-6. PANEL (DOCK TOP IP) BLOCK
2-5. CASE (DOCK BOTTOM)
2
three claws
Note: When installing the case (dock bottom),
match the position of the shaft with the ditch.
Note: When installing the case (dock bottom),
match the position of the shaft with the ditch.
1
Remove the case (dock bottom) in
the direction of an arrow.
3
case (dock bottom)
– Dock block rear side view –
2
panel (dock top IP) block
1
four screws
(BVTP2.6)
– Dock block rear side view –
CMT-V50iP
11
2-8. LEVER
(CAM)
2-7. SPRING
(LOADING)
1
Remove the spring (loading)
from the hook.
3
spring (loading)
– Panel (dock top IP) block rear side view –
2
float screw (S)
ditch
spring (loading)
Spring (loading) setting
Note: When installing the spring (loading),
put a tip into the ditch.
1
float screw (S)
2
spring (cam)
3
lever (cam)
– Panel (dock top IP) block rear bottom side view –
CMT-V50iP
12
2-9. SPRING
(LID)
4
spring (lid)
2
shaft
2
shaft
3
lid (dock)
– Panel (dock top IP) block rear side view –
spring (lid)
Spring (lid) setting
1
Remove the spring (lid)
from the hook.
Note: Spring (lid) is being fixed to
the hook with adhesives.
When installing spring (lid)
to the hook, please fix
with adhesives similarly.
2-10. SPRING (FOOT)
1
Remove the spring (foot)
from the ditch.
4
spring (foot)
spring (foot)
3
foot (dock panel)
foot (dock panel)
2
shaft
2
shaft
– Panel (dock bottom) block rear bottom side view –
2
shaft
Spring (foot) setting
spring (foot)
panel (dock bottom)
foot (dock panel)
Spring (foot) setting
Click on the first or last page to see other CMT-V50IP service manuals if exist.