Sony BDV-IS1000 / HT-IS100 / SA-WIS100 / SS-IS15 Service Manual ▷ View online
SA-WIS100/SS-IS15
73
Pin No.
Pin Name
I/O
Description
99
OVSS
-
Ground terminal (for I/O)
100
RAS
O
Row address strobe signal output to the SD-RAM
101
DQM
O
Data mask signal output to the SD-RAM
102
CAS
O
Column address strobe signal output to the SD-RAM
103
MCLK
O
Clock signal output to the SD-RAM
104
WE
O
Write enable signal output to the SD-RAM
105, 106
TEST3, TEST4
I
Test terminal Fixed at "L" in this set
107
OVSS
-
Ground terminal (for I/O)
108
OVDD
-
Power supply terminal (+3.3V) (for I/O)
109
CVDD
-
Power supply terminal (+2.5V) (for core)
110 to 113
MD7, MD8, MD6, MD9
I/O
Two-way data bus with the SD-RAM
114
OVDD
-
Power supply terminal (+3.3V) (for I/O)
115
OVSS
-
Ground terminal (for I/O)
116 to 119
MD5, MD10, MD4,
MD11
I/O
Two-way data bus with the SD-RAM
120
OVDD
-
Power supply terminal (+3.3V) (for I/O)
121
OVSS
-
Ground terminal (for I/O)
122 to 125
MD3, MD12, MD2,
MD13
I/O
Two-way data bus with the SD-RAM
126
OVSS
-
Ground terminal (for I/O)
127
CVSS
-
Ground terminal (for core)
128
OVDD
-
Power supply terminal (+3.3V) (for I/O)
129 to 132
MD1, MD14, MD0,
MD15
I/O
Two-way data bus with the SD-RAM
133
SLV
I
Slave address setting terminal "L": 0 x 72, "H": 0 x 70 Fixed at "H" in this set
134
RFFO
O
MPEG fl ag (repeat fi rst fi eld fl ag) output terminal Not used
135
SDA
I/O
Two-way I2C data bus with the EEPROM, HDMI receiver, HDMI transceiver, HDMI controller
and video decoder
and video decoder
136
SCL
I
I2C clock signal input from the HDMI controller
137
SRN
I
Reset signal input from the HDMI controller "L": reset
138
OVSS
-
Ground terminal (for I/O)
139
CVDD
-
Power supply terminal (+2.5V) (for core)
140
PLL_VDD
-
Power supply terminal (+2.5V) (for PLL)
141
VPDX
-
Not used
142
TEST6
I
Test terminal Fixed at "L" in this set
143
PLL_GND
-
Ground terminal (for I/O)
144
IVDD
-
Power supply terminal (+3.3V) (for I/O)
74
SA-WIS100/SS-IS15
SECTION 7
EXPLODED VIEWS
1
X-2189-215-1 FRAME
ASSY,
GRILLE
2
3-089-380-01 DAMPER
3
2-159-920-01 SCREW, HDD DAMPER
4
4-104-567-11 CUSHION
(70T100)
#2
7-685-646-79 SCREW +BVTP 3X8 TYPE2 IT-3
#3
7-685-871-01 SCREW +BVTT 3X6 (S)
Ref. No.
Part No.
Description
Remark
Ref. No.
Part No.
Description
Remark
Note:
• -XX and -X mean standardized parts, so
• -XX and -X mean standardized parts, so
they may have some difference from the
original one.
original one.
• Items marked “*” are not stocked since
they are seldom required for routine ser-
vice. Some delay should be anticipated
when ordering these items.
vice. Some delay should be anticipated
when ordering these items.
• The mechanical parts with no reference
number in the exploded views are not sup-
plied.
plied.
• Color Indication of Appearance Parts Ex-
ample:
KNOB, BALANCE (WHITE) . . . (RED)
↑
↑
Parts Color Cabinet’s Color
• Abbreviation
AR :
AR :
Argentina
model
AUS :
Australian
model
CND :
Canadian
model
7-1. OVERALL SECTION (SA-WIS100)
1
not
supplied
supplied
speaker cabinet section
not supplied
#3
#2
top panel section
not supplied
(CONNECT board)
(CONNECT board)
AMP block assy
#2
#2
#2
2
4
2
2
2
3
The components identifi ed by mark 9 con-
tain confi dential information.
Strictly follow the instructions whenever the
components are repaired and/or replaced.
tain confi dential information.
Strictly follow the instructions whenever the
components are repaired and/or replaced.
Les composants identifi és par la marque
9 contiennent des informations confi den-
tielles.
Suivre scrupuleusement les instructions
chaque fois qu’un composant est remplacé
et / ou réparé.
9 contiennent des informations confi den-
tielles.
Suivre scrupuleusement les instructions
chaque fois qu’un composant est remplacé
et / ou réparé.
The components identifi ed by mark 0
or dotted line with mark 0 are critical for
safety.
Replace only with part number specifi ed.
or dotted line with mark 0 are critical for
safety.
Replace only with part number specifi ed.
Les composants identifi és par une marque
0 sont critiques pour la sécurité.
Ne les remplacer que par une pièce portant
le numéro spécifi é.
0 sont critiques pour la sécurité.
Ne les remplacer que par une pièce portant
le numéro spécifi é.
Ver. 1.1
75
SA-WIS100/SS-IS15
7-2. TOP PANEL SECTION (SA-WIS100)
51
3-087-053-01 +BVTP2.6
(3CR)
52
X-2318-417-1 BUTTON
(S)
ASSY
53
X-2318-418-1 BUTTON (POWER) ASSY (?/1)
54
3-293-783-01 ESCUTCHEON
55
3-293-786-01 HOUSING
LED
56
3-293-779-01 WINDOW (US, CND, AUS, AR)
56
3-293-779-21 WINDOW (AEP, UK)
57
3-293-777-02 PANEL,
TOP
58
3-293-784-01 FILTER,
WINE
59
A-1509-535-A DISPLAY BOARD, COMPLETE
60
1-828-315-51 WIRE (FLAT TYPE) (11 CORE)
61
4-235-399-01 CATCHER
62
3-875-134-01 BUSHING,
PANEL
(TYPE3)
63
1-828-002-51 WIRE (FLAT TYPE) (17 CORE)
#6
7-685-135-19 SCREW +P 2.6X10 TYPE2 NONSLIT
Ref. No.
Part No.
Description
Remark
Ref. No.
Part No.
Description
Remark
56
57
55
54
53
52
58
59
not supplied
not supplied
(KEY board)
(KEY board)
51
60
51
61
62
not supplied
#6
63
not supplied
Note: Please exchange all at the same time when you ex-
change the escutchen (Ref No. 54), housing LED
(Ref. No. 55), window (Ref. No. 56) or top panel (Ref.
No. 57).
(Ref. No. 55), window (Ref. No. 56) or top panel (Ref.
No. 57).
Ver. 1.1
76
SA-WIS100/SS-IS15
7-3. SPEAKER CABINET SECTION (SA-WIS100)
101
4-229-966-02 SCREW (4X16), +BV TAPPING
102
4-251-067-01 PACKING (AL FRONT)
103
3-293-794-01 REFLECTOR
104
A-1508-429-A CABINET
ASSY,
SPEAKER
SP001
1-826-937-11 LOUDSPEAKER (16 cm) (SUB WOOFER)
SP002
1-826-658-11 LOUDSPEAKER (12 cm) (MIDDLE)
#7
7-685-661-19 SCREW +BVTP 4X12 TYPE2 N-S
Ref. No.
Part No.
Description
Remark
Ref. No.
Part No.
Description
Remark
SP002
SP001
not
supplied
supplied
#7
101
104
103
101
102
Click on the first or last page to see other BDV-IS1000 / HT-IS100 / SA-WIS100 / SS-IS15 service manuals if exist.