DOWNLOAD Sharp LC-26P50E Service Manual ↓ Size: 1.69 MB | Pages: 47 in PDF or view online for FREE

13

• 

Ensure you unplug the power cord before cleaning the LCD. 

• 

The cabinet as well as the operation panel is made of plastic. Avoid
using benzene or thinner, as these can damage the finish on the
cabinet.

• 

Do not use volatile agents such as insecticides on the LCD.
Do not attach rubber or plastic items on the LCD for long periods of
time.
The effects of some of the agents in the plastic may cause damage
to the quality or finish of the LCD.

 

• 

Wipe off dirt gently with a soft flannel cloth.

 

• 

When the dirt is hard to remove, soak a cloth in a neutral detergent diluted with water,
wring the cloth well and then wipe the LCD.
Strong cleaning detergents may discolour, warp or damage the coating on the LCD.
Ensure you test on a small, inconspicuous area on the LCD before using.

• 

Use a vacuum cleaner to clean dust from the exhaust vent and the intake vent. 

14

(Available from Sharp Sales)

(Commercially Available)

15

Turn off the TV by pressing the power button. Press and hold down RESET and press the
power button on the TV to turn it on.
All setting items (except TV channel) return to the factory pre-setting.

You can run the Auto Installation again by using the following steps.

Turn on the power of the TV.

Press MENU. (Make sure the menu screen displays.)

Press cursor left/right to select “Setup”.

Press cursor up/down to select “Auto Installation”, and then press OK.

Press cursor left/right to select “Yes”, and then press OK.

 

Press RESET if the TV cannot return to its original state after performing various operations.
• AV Mode resets to USER. 

• Surround resets to Off.

• Analogue TV channel resets to channel 1. 

• Image position initialises.

• Audio setting initialises.

• Pressing RESET will not work if the TV is in standby mode (indicator lights red).
• Pressing RESET will not delete channel preset and PIN. See page 14 for resetting the PIN
when you know it. See above for initialising to the factory preset values when you forget your
PIN.
Press SYSTEM RESET if the TV does not operate after starting up.

16

 When the factory settings have been made, all user setting data, including the

channel settings, are initialised. (The adjustments done in the adjustment process mode are
not initialised.) Keep this in mind when initialising these settings.

• 

Enter the adjustment process mode.

• 

Bring the cursor on to [INDUSTRY INIT] on page
2/12.

• 

Use the [Volume +-] key to select a region from
[AUTO/EURO/UK/ITALY/ FRANCE/RUSSIA] and
press [ENTER]. “////////” appears and initialization
starts.After a while, “SUCCESS—[regional code]”
appears and the setting is complete.

Note: Never turn the power off during
initialisation.
The background appears green when succeeded,
and red when failed.
*Never turn off the power during the initialisation
process.

Factory settings

See to below caution

The following settings will be back to their factory
defaults.
1. User settings
2. Channel data (e.g. broadcast frequencies)
3. Password data

After adjustments, exit the adjustment process mode.
To exit the adjustment process mode, unplug the AC power cord from the outlet to forcibly
turn off the power.
When the power is turned off with the remote control, unplug the AC power cord and plug it
back in (wait approximately 10 seconds before plugging in the AC power cord).