DOWNLOAD Sharp XV-Z12000 (serv.man35) Service Manual ↓ Size: 2.58 MB | Pages: 35 in PDF or view online for FREE

Check

Page

• Projector power cord is not plugged into the wall outlet.

16

• Power to the external connected devices is off.

–

• The selected input mode is wrong.

35

• Cables incorrectly connected to rear panel of the projector.

17-26

• Remote control batteries have run out.

13

• External output has not been set when connecting notebook computer.

–

• The cover of the lamp unit is not installed correctly.

81

• The selected “Signal Type” is wrong.

69

• The video signal format of the video equipment is not set correctly.

70

• “Bright” is set to minimum position.

47

• Picture adjustments are incorrectly set.

47

(Video Input only)

• Video input system is incorrectly set.

70

(INPUT 1, 2 and 5 only)

• Input signal type is incorrectly set.

69

• Adjust the focus.

28

• The projection distance exceeds the focus range.

30-31

(Computer Input only)

• Perform “Fine Sync” Adjustments (“Clock” Adjustment)

57

• Perform “Fine Sync” Adjustments (“Phase” Adjustment)

57

• Noise will appear depending on the computer.

–

• The “DNR” (Digital Noise Reduction) setting is not correct.

50

• If the picture is normal, the sound is due to cabinet shrinkage

–

caused by a room temperature changes. This will not affect
operation or performance.

• See “Maintenance Indicators”.

78

• “LED” is set to “OFF”.

67

Problem

Colour is faded or poor.

Picture is blurred;

noise appears.

No picture and no sound

or projector does not start.

An unusual sound is

occasionally heard

from the cabinet.

Maintenance

indicator illuminates.

Power indicator and

lamp indicator do not

come on while projecting.

XV_Z12000E_E_p89_94.p65

03.10.27, 10:47 AM

89

Check

Problem

Page

• Change the input signal type setting.

69

• The lamp indicator is blinking in red. Replace the lamp.

78

• Picture adjustments are incorrectly set.

47

• In the case of transmitting RS-232C commands from a computer

84

during standby, it takes a maximum of 30 seconds for the
computer to receive the response code. Set the response code
waiting time of the computer to 30 seconds or more.

Picture is green on

INPUT 1 or 2 COMPO-

NENT.

Picture is pink (no green)

on INPUT 1 or 2 RGB.

Picture is dark.

Picture is too bright and

whitish.

A response code cannot

be received when the

projector was attempted

to be controlled using

RS-232C commands

from a computer during

standby.

XV_Z12000E_E_p89_94.p65

03.10.27, 10:47 AM

90

Projector
XV-Z12000
NTSC 3.58/NTSC 4.43/PAL/PAL-M/PAL-N/PAL 60/SECAM
DTV480I/DTV480P/DTV720P/DTV1080I
DLP chip, RGB optical shutter method
Panel size: 0.8"
Display method: Single Panel Digital Micromirror Device (DMD™) by Texas Instruments
Drive method: Digital Light Processing (DLP™)
No. of dots: 921,600 dots (1,280 [H] 

× 720 [V])

1–1.35 

× zoom lens, F2.5–8, f = 32.5–44.0 mm

270 W SHP lamp
4-pin Mini DIN connector (INPUT 3)
Y (luminance signal): 1.0 Vp-p, sync negative, 75 

Ω terminated

C (chrominance signal): Burst 0.286 Vp-p, 75 

Ω terminated

RCA Connector (INPUT 1, 2)
Y: 1.0 Vp-p, sync negative, 75 

Ω  terminated

P

B

: 0.7 Vp-p, 75 

Ω  terminated

P

R

: 0.7 Vp-p, 75 

Ω  terminated

520 TV lines (NTSC 3.58 input), 750 TV lines (DTV 720P input)
DVI-I terminal: (INPUT 5)/RCA connector: INPUT 1/2
<Digital>
Input impedance

50 

Ω

Input level

250-1000 mV

<Analog>
Input Impedance

75 

Ω

Input level

0.7 Vp-p

<Synchronization signal>

••••• Separate sync / Composite sync

Input level

TTL level

Input impedance

1 K

Ω

••••• Green on sync

Input level (Synchronizing input)

0.286 Vp-p

Input Impedance

75 

Ω

RCA Connector: VIDEO (INPUT 4), composite video, 1.0 Vp-p, sync negative, 75 

Ω

terminated
9-pin D-sub connector (RS-232C Port)
12–120 MHz
43–100 Hz
15–81 kHz
AC 100–240 V (HONG KONG: 220 V)
3.7 A (When using AC 100 V) / (HONG KONG: 1.6 A)
50/60 Hz (HONG KONG: 50 Hz)
365 W (HONG KONG: 345 W)
About 0.1 W (When using 100 V)
1,400 BTU/hour
+5°C to +35°C
–20°C to +60°C
Plastic
38 kHz
475 (W) 

× 178 (H) × 406 (D) mm (main body only)

475 (W) 

× 178 (H) × 496 (D) mm (including terminal cover)

9.4 kg
Remote control, Two AA size batteries, Power cord, DVI to 15-pin D-sub adaptor, 21-pin
RCA conversion adaptor, Video cable, Terminal cover, Lens cap (attached), SharpVision
Manager Software CD-ROM, Projector operation manual, SharpVision Manager operation
manual
Lamp unit (Lamp/cage module) (BQC-XVZ100005), Remote control (RRMCGA216WJSA), AA size
batteries, Power cord for Europe (except U.K.) and Korea: QACCVA011WJPZ, Power cord for U.K.,
Hong Kong and Singapore: QACCBA036WJPZ, Power cord for Australia and New Zealand:
QACCLA018WJPZ, DVI to 15-pin D-sub adaptor (QCNWGA010WJZZ), 21-pin RCA conversion adap-
tor (QSOCZ0361CEZZ), Video cable (QCNWGA001WJPZ), Lens cap (PCAPH1056CESA), Termi-
nal cover (CCOVA1985CE03),  SharpVision Manager Software CD-ROM (UDSKAA040WJZZ), Pro-
jector operation manuals; for European 7 languages (TINS-A972WJZZ (this manual)) / for Chinese,
Korean and Arabic (TINS-A973WJZZ), SharpVision Manager operation manual (TINS-B097WJZZ)

Product type

Model

Video system

Display method

DLP panel

Lens

Projection lamp

S-video input signal

Component input signal

Horizontal resolution

RGB input signal

Video input signal

Computer control signal

Pixel clock

Vertical frequency

Horizontal frequency

Rated voltage

Input current

Rated frequency

Power consumption (normal)

Power consumption (standby)

Heat dissipation

Operating temperature

Storage temperature

Cabinet

I/R carrier frequency

Dimensions (approx.)

Weight (approx.)

Supplied accessories

Replacement parts

This SHARP projector uses a DMD Chip. This very sophis-
ticated panel contains 921,600 pixels. As with any high tech-
nology electronic equipment such as large screen TVs, video
systems and video cameras, there are certain acceptable
tolerances that the equipment must conform to.

This unit has some inactive pixels within acceptable toler-
ances which may result in inactive dots on the picture screen.
This will not affect the picture quality or the life expectancy
of the unit.

Specifications are subject to change without notice.

XV_Z12000E_E_p89_94.p65

03.10.27, 10:47 AM

91

475

178

406

XV_Z12000E_E_p89_94.p65

03.10.27, 10:47 AM

92