DOWNLOAD Sharp XG-XV2E (serv.man2) Service Manual ↓ Size: 659.12 KB | Pages: 47 in PDF or view online for FREE

1-1. Remove the intake cover.
1-2. Remove the screws and detach the lamp cage cover.
1-3. Remove the three screws off the lamp cage unit.
1-4. Pull out the lamp cage unit.
Notes:

»

Before the replacement, turn off the projector’s power button, make sure the cooling fan comes to a complete
stop, and unplug the power cord.

»

The lamp may be still very hot. Turn off the power button, unplug the power cord and wait for at least 1 hour
before staring the job.

»

In fitting the lamp cage unit back into position, make sure the connector is at the top position.

Lamp Cage Unit

1-3

1-3

1-4

1-2

1-1

Lamp Cage Cover

Intake Cover

2-1

2-3

2-2

2-1

2-1

Front Cabinet

Infrared R/C Receiver Unit

A

B

C

D

2-1. Remove the four right and left screws from the bottom of the front cabinet.
2-2. Gently press down on the hooks A, B, C and D of the top cabinet to unhook the front cabinet. Detach the

front cabinet.

2-3. Disconnect the remote control connector.

3-1. Remove the five screws from the top and bottom of the rear cabinet.
3-2. Disconnect the speaker connector.
3-3. Slide back the top cabinet to separate the top and rear cabinets.

3-2

3-1

3-1

Rear Cabinet

Top Cabinet

3-3

4-1. Put a bladed screwdriver in the rightmost hole of the screws cover. Pull and unlock the right end of the

screws cover, and pull and detach the entire screws cover.

4-2. Remove the twelve side screws.
4-3. Remove the two screws off the side cabinet.
4-4. Disconnect the video terminal cover.
4-5. Disconnect the membrane switch connector.
4-6. Pull down and detach the left side cabinet.
4-7. Remove the two screws off the LED PWB assembly.

4-2

4-4

4-2

4-2

4-6

4-3

4-5

4-3

4-7

LED Unit

Left-Side
Cabinet

Video Terminal Cover
(attached only when the video
board unit is not used)

4-4

4-2

4-2

4-1

Video Board Unit
(for XG-XV2M as 
well as Australian 
and NewZealand 
versions of 
XG-XV2E)

Video Terminal Cover
(for XG-XV2M as well as 
Australian and NewZealand 
versions of XG-XV2E)