Sharp PG-M15 (serv.man3) Service Manual ▷ View online
16
PG-M15X
PG-M15S
AN-M15T
Cut three cable tie
from Optical Engine
Module.
from Optical Engine
Module.
Step 12
Step 13
Unplug three
Connecting Cords
of DC to DC PWB Unit
Connecting Cords
of DC to DC PWB Unit
2-5
2-5. Remove one screw of DC to DC PWB Unit Holder, unplug three Connecting Cords, and then detach DC to
DC PWB Unit.
(Step 12,13.)
(Step 12,13.)
2-6. Remove push bar, push bar spring, and rubber. (refer to step 14~16.)
Step 14
Step 15
Step 16
2-6
2-6
17
PG-M15X
PG-M15S
AN-M15T
2-7. Unplug six wires of Thermal PWB Unit. (Step 17.)
2-8. Remove 5 screws from optical engine module (Step 18~20.)
2-9. Remove 2 screws from projection lens cover. (Step 21.)
2-10. Remove optical engine module, projection lens cover, and Thermal Unit. (Step 22, 23.)
2-8. Remove 5 screws from optical engine module (Step 18~20.)
2-9. Remove 2 screws from projection lens cover. (Step 21.)
2-10. Remove optical engine module, projection lens cover, and Thermal Unit. (Step 22, 23.)
Step 18
Step 19
2-8
2-8
Step 20
Step 21
2-9
Step 22
Step 23
2-10
Step 17
2-7
18
PG-M15X
PG-M15S
AN-M15T
Optical Engine Module
Thermal PWB Unit
Projection Lens Cover
DMD Off-Light Vent
2-7
2-8
2-6
2-9
Speaker
Push Bar Spring
Pudh Bar
Leakage Rubber
19
PG-M15X
PG-M15S
AN-M15T
3. Disassemble Ballast PWB unit
3-1. Remove two screws and detach Terminal Sheet Holder.
3-2. Remove two screws and detach Grounding Sheet.
3-3. Remove two screws and detach AC Code Fix.
3-4. Remove two screws and detach ignitor cable from Lamp Housing.
3-5. Remove two screws and detach Ballast PWB unit.
3-2. Remove two screws and detach Grounding Sheet.
3-3. Remove two screws and detach AC Code Fix.
3-4. Remove two screws and detach ignitor cable from Lamp Housing.
3-5. Remove two screws and detach Ballast PWB unit.
AC Code Fix
Grounding Sheet
Terminal Sheet Holder
Ballast PWB unit
3-2
3-3
3-4
3-1
3-5