Sharp PG-M15 (serv.man3) Service Manual ▷ View online
17
PG-M15X
PG-M15S
AN-M15T
2-7. Unplug six wires of Thermal PWB Unit. (Step 17.)
2-8. Remove 5 screws from optical engine module (Step 18~20.)
2-9. Remove 2 screws from projection lens cover. (Step 21.)
2-10. Remove optical engine module, projection lens cover, and Thermal Unit. (Step 22, 23.)
2-8. Remove 5 screws from optical engine module (Step 18~20.)
2-9. Remove 2 screws from projection lens cover. (Step 21.)
2-10. Remove optical engine module, projection lens cover, and Thermal Unit. (Step 22, 23.)
Step 18
Step 19
2-8
2-8
Step 20
Step 21
2-9
Step 22
Step 23
2-10
Step 17
2-7
18
PG-M15X
PG-M15S
AN-M15T
Optical Engine Module
Thermal PWB Unit
Projection Lens Cover
DMD Off-Light Vent
2-7
2-8
2-6
2-9
Speaker
Push Bar Spring
Pudh Bar
Leakage Rubber
19
PG-M15X
PG-M15S
AN-M15T
3. Disassemble Ballast PWB unit
3-1. Remove two screws and detach Terminal Sheet Holder.
3-2. Remove two screws and detach Grounding Sheet.
3-3. Remove two screws and detach AC Code Fix.
3-4. Remove two screws and detach ignitor cable from Lamp Housing.
3-5. Remove two screws and detach Ballast PWB unit.
3-2. Remove two screws and detach Grounding Sheet.
3-3. Remove two screws and detach AC Code Fix.
3-4. Remove two screws and detach ignitor cable from Lamp Housing.
3-5. Remove two screws and detach Ballast PWB unit.
AC Code Fix
Grounding Sheet
Terminal Sheet Holder
Ballast PWB unit
3-2
3-3
3-4
3-1
3-5
20
PG-M15X
PG-M15S
AN-M15T
4. Disassemble Lamp Housing
4-1. Loosen two screws and remove Lamp Cover.
4-2. Loosen three screws and lift Lamp.
4-3. Remove screw and detach Output Air Guide and Output Rubber duct.
4-4. Remove three screws and detach Lamp Housing.
4-5. Remove screw and nut then detach Fan from Lamp Housing.
4-6. Remove four screws and detach Blower Wind Guide from Lamp Housing.
4-7. Remove thermal Fuse from lamp Housing.
4-2. Loosen three screws and lift Lamp.
4-3. Remove screw and detach Output Air Guide and Output Rubber duct.
4-4. Remove three screws and detach Lamp Housing.
4-5. Remove screw and nut then detach Fan from Lamp Housing.
4-6. Remove four screws and detach Blower Wind Guide from Lamp Housing.
4-7. Remove thermal Fuse from lamp Housing.
Lamp Housing
Lamp Cover
Blower Wind
Guide
Guide
Lamp
Bottom Cover
Output
Air Guide
Air Guide
Output
Rubber duct
Rubber duct
Spacer
Fan
4-1
4-4
4-5
4-7
4-6
4-3
4-2
Thermal
Fuse
Fuse
Click on the first or last page to see other PG-M15 (serv.man3) service manuals if exist.