DOWNLOAD Sharp PG-C30XE Service Manual ↓ Size: 846.35 KB | Pages: 48 in PDF or view online for FREE

13

• 

Plug the power cord into the AC socket of the projector.

 

• 

While pressing simultaneously “ADJ RIGHT”, “ADJ DOWN” and
“ENTER” on the projector, press “ON” on the projector.

• 

“LAMP 100%” is displayed, indicating that the lamp timer is
reset.

• 

Make sure to reset the lamp timer only when replacing the lamp. If you reset the lamp timer and
continue to use the same lamp, this may cause the lamp to become damaged or explode.

14

• 

Be sure to unplug the power cord before cleaning the projector.

• 

The cabinet as well as the operation panel is made of plastic. Avoid using benzene or
thinner, as these can damage the finish on the cabinet.

• 

Do not use volatile agents such as insecticides on the projector.
Do not attach rubber or plastic items on the projector for long time.
The effects of some of the agents in the plastic may cause damage to the quality or finish
of the projector.

 

• 

Wipe off dirt gently with a soft flannel cloth.

 

• 

When the dirt is hard to remove, soak a cloth in a neutral detergent diluted with water,
wring the cloth well and then wipe the projector.
Strong cleaning detergents may discolour, warp or damage the coating on the projector.
Make sure to test on a small, inconspicuous area on the projector before using.

• 

Use a commercially available blower or lens cleaning paper (for glasses and camera
lenses) for cleaning the lens. Do not use any liquid type-cleaning agents, as they may
wear off the coating film on the surface of the lens.

 

• 

As the surface of the lens can easily get damaged, be sure not to scrape or hit the lens.

• 

Use a vacuum cleaner to clean dust from the exhaust vent and the intake vent. 

15

• 

This projector is equipped with air filters to
ensure the optimal operating condition of
the projector.

• 

The air filters should be cleaned every 100
hours of use. Clean the filters more often
when the projector is used in a dusty or
smoky location.

 

• 

Ask your nearest Sharp Authorised Projector Dealer or Service Centre to exchange the
filter (PFILDA0076CEZZ) when it is no longer possible to clean.

• 

Press “OFF”. Wait until the cooling fan stops.

 

• 

Turn over the projector. Grab the tab and open the filter
cover in the direction of the arrow.

 

• 

Pick the air filter up with your fingers and lift it out of the filter
cover.

 

16

• 

Clean the dust off the air filter and cover with a vacuum cleaner
extension hose.

• 

Place the air filter underneath the tabs on the filter cover.

 

• 

Close the filter cover in the direction of the arrow to close it.

 

• 

Be sure the filter cover is securely installed. The power will not turn on unless it is
correctly installed.

• 

If dust or dirt has collected inside the bottom air filter (not removable), clean the filter with
a vacuum cleaner extension hose.