DOWNLOAD Sharp PG-A10X (serv.man33) Service Manual ↓ Size: 1.05 MB | Pages: 20 in PDF or view online for FREE

Check

• Projector power cord is not plugged into the wall outlet.
• Power to the external connected devices is off.
• The selected input mode is wrong.
• The AV MUTE function is working.
• Cables incorrectly connected to rear panel of the projector.
• Remote control batteries have run out.
• External output has not been set when connecting notebook computer.
• The filter/lamp unit cover is not installed correctly.
• Cables incorrectly connected to the rear panel of the projector.
• “Bright” is set to minimum position.

• Picture adjustments are incorrectly set.
(Video Input only)

• Video input system is incorrectly set.
(INPUT 1 only)

• Input signal type (RGB/Component) is incorrectly set.

• Adjust the focus.
• The projection distance exceeds the focus range.
(Computer Input only)

• Perform “Fine Sync” Adjustments (“Clock” Adjustment)

• Perform “Fine Sync” Adjustments (“Phase” Adjustment)

• Noise may appear depending on the computer.

• Cables incorrectly connected to rear panel of projector.
• Volume is set to minimum.

• If the picture is normal, the sound is due to cabinet shrinkage

caused by room temperature changes. This will not affect
operation or performance.

• See “Maintenance Indicators”.

• The keylock is set.

If the keylock is set to ON, all the buttons are locked.

Problem

An unusual sound is

occasionally heard

from the cabinet.

Maintenance

indicator illuminates.

Power cannot be turned

on or off using the power

buttons on the projector.

Page

—

—

—

Sound is heard but no

picture appears.

Color is faded or poor.

Picture is blurred;

noise appears.

Picture appears but no

sound is heard.

No picture and no sound

or projector does not start.

Check

Problem

Page

Picture is green on

INPUT 1 COMPONENT.

Picture is pink (no green)

on INPUT 1 RGB.

Picture is dark.

Picture is too bright and

whitish.

• Change the input signal type setting.

• The lamp replacement indicator is illuminating in red. Replace

the lamp.

• Picture adjustments are incorrectly set.

Sharp Electronics Corporation
1-888-GO-SHARP (1-888-467-4277)
[email protected]
http://www.sharplcd.com

Sharp Electronics of Canada Ltd.
(905) 568-7140
http://www.sharp.ca

Sharp Electronics Corporation Mexico
Branch
(525) 716-9000
http://www.sharp.com.mx

Sharp Electronics Corp. Latin American
Group
(305) 264-2277
[email protected]
http://www.siempresharp.com

Sharp Electronics (Europe) GMBH
01805-234675
http://www.sharp.de

Sharp Electronics (U.K.) Ltd.
0161-205-2333
[email protected]
http://www.sharp.co.uk

Sharp Electronics (Italy) S.P.A.
(39) 02-89595-1
http://www.sharp.it

Sharp Electronics France
01 49 90 35 40
[email protected]
http://www.sharp.fr

Sharp Electronica Espana, S.A.
93 5819700
[email protected]
http://www.sharp.es

Sharp Electronics (Schweiz) AG
0041 1 846 63 11
[email protected]
http://www.sharp.ch

Sharp Electronics ( Nordic ) AB
(46) 8 6343600
[email protected]
http://www.sharp.se

Sharp Electronics Austria (Ges.m.b.H.)
0043 1 727 19 123
[email protected]
http://www.sharp.at

SHARP Electronics Benelux BV
0900-SHARPCE (0900-7427723)
Nederland
9900-0159 Belgium
http://www.sharp.nl
http://www.sharp.be
http://www.sharp.lu

Sharp Corporation of Australia
Pty. Ltd.
1300-135-022
http://www.sharp.net.au

Sharp Corporation of New Zealand
(09) 634-2059, (09) 636-6972
http://www.sharpnz.co.nz

Sharp-Roxy Sales (S) Pte. Ltd.
65-226-6556
[email protected]
http://www.sharp.com.sg

Sharp-Roxy (HK) Ltd.
(852) 2410-2623
[email protected]
http://www.sharp.com.hk

Sharp Corporation (Taiwan)
0800-025111
http://www.sharp-scot.com.tw

Sharp-Roxy Sales & Service Co.
(60) 3-5125678

Sharp Middle East Fze
971-4-81-5311
[email protected]

Sharp Thebnakorn Co. Ltd.
02-236-0170
[email protected]
http://www.sharp-th.com

Sharp Electronics Incorporated of
Korea
(82) 2-3660-2002
[email protected]
http://www.sharpkorea.co.kr

Sharp Business Systems (India)
Limited
(91) 11- 6431313
[email protected]

LCD Projector
PG-A10X / PG-A10S
NTSC3.58/NTSC4.43/PAL/PAL-M/PAL-N/PAL-60/SECAM/
DTV480I/DTV480P/DTV540P/DTV580I/DTV580P/DTV720P/DTV1035I/DTV1080I
LCD panel 

× 3, RGB optical shutter method

Panel size: 0.79" (20.0 mm) (12 [H] 

× 16 [W] mm)

No. of dots: [PG-A10X] 786,432 dots (1,024 [H] 

× 768 [V])

[PG-A10S] 480,000 dots (800 [H] 

× 600 [V])

1–1.2 

× zoom lens, F1.9–2.2, f = 26–31 mm

SHP 165 W lamp
15-pin mini D-sub connector
Y: 1.0 Vp-p, sync negative, 75 

Ω terminated

P

B

: 0.7 Vp-p, 75 

Ω terminated

P

R

: 0.7 Vp-p, 75 

Ω terminated

[PG-A10X] 700 TV lines (DTV720P)
[PG-A10S] 520 TV lines (DTV720P)
15-pin mini D-sub connector
RGB separate/sync on green type analog input: 0–0.7 Vp-p, positive, 75 

Ω terminated

HORIZONTAL SYNC. SIGNAL: TTL level (positive/negative)
VERTICAL SYNC. SIGNAL: Same as above
4-pin mini DIN connector
Y (luminance signal): 1.0 Vp-p, sync negative, 75 

Ω terminated

C (chrominance signal): Burst 0.286 Vp-p, 75 

Ω terminated

RCA connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75 

Ω

terminated
9-pin mini DIN connector
12–108 MHz
43–85 Hz
15–70 kHz
ø3.5 mm minijack: AUDIO, 0.5 Vrms, more than 47 k

Ω (stereo)

1.0 W (monaural)
2.8 cm round 

× 1

AC 100–240 V
2.4 A
50/60 Hz
240 W (Standard mode)/190 W (Eco mode) with AC 100 V
226 W (Standard mode)/182 W (Eco mode) with AC 240 V
5 W (AC 100 V) – 8 W (AC 240 V)
900 BTU/hour (Standard mode)/710 BTU/hour (Eco mode) with AC 100 V
850 BTU/hour (Standard mode)/680 BTU/hour (Eco mode) with AC 240 V
41°F to 95°F (+5°C to +35°C)
–4°F to 140°F (–20°C to +60°C)
Plastic
38 kHz
11 

45

/

64

" 

× 3 

13

/

64

" 

× 9 

1

/

32

" (297 (W) 

× 81 (H) × 229 (D) mm) (main body only)

11 

45

/

64

" 

× 3 

33

/

64

" 

× 9 

1

/

32

" (297 (W) 

× 89 (H) × 229 (D) mm) (including adjustment foot

and projecting parts)
6.4 lbs. (2.9 kg)
Remote control, Two R-6 batteries, Power cord for U.S., Canada etc. (6', 1.8 m), Power cord
for Europe, except U.K. (6', 1.8 m), Power cord for U.K., Hong Kong and Singapore (6', 1.8
m), Power cord for Australia, New Zealand and Oceania (6', 1.8 m), RGB cable (9'10",
3.0 m), DIN-D-sub RS-232C adaptor (5 

57

/

64

", 15 cm), Carrying case, Lens cap (attached),

Extra air filter, Projector manual and technical reference CD-ROM, “QUICK GUIDE” label,
Operation manual
Lamp unit (Lamp/cage module) (BQC-PGA10X//1), Remote control (RRMCGA138WJSA),
Two R-6 batteries (“AA” size, UM/SUM-3, HP-7, or similar), Power cord for U.S., Canada etc.
(QACCDA016WJPZ), Power cord for Europe, except U.K. (QACCVA006WJPZ), Power cord
for U.K., Hong Kong and Singapore (QACCBA015WJPZ), Power cord for Australia, New
Zealand and Oceania (QACCLA005WJPZ), RGB cable (QCNWGA012WJPZ), DIN-D-sub
RS-232C adaptor (QCNWGA015WJPZ), Carrying case (GCASNA006WJSA), Lens cap
(CCAPHA007WJ01), Air filter (PFILDA008WJZZ), Projector manual and technical reference
CD-ROM (UDSKAA022WJN1), “QUICK GUIDE” label (TLABZA191WJZZ), Operation manual
(TINS-A505WJN1)

Product type

Model

Video system

Display method

LCD panel

Standard lens

Projection lamp

Component input signal

(INPUT1)

Horizontal resolution

Computer RGB input signal

(INPUT 1)

S-video input signal

(INPUT 2)

Video input signal

(INPUT 3)

Computer control signal (RS-232C)

Pixel clock

Vertical frequency

Horizontal frequency

Audio input signal

Audio output

Speaker system

Rated voltage

Input current

Rated frequency

Power consumption

Power consumption (standby)

Heat dissipation

Operating temperature

Storage temperature

Cabinet

I/R carrier frequency

Dimensions (approx.)

Weight (approx.)

Supplied accessories

Replacement parts

This SHARP projector uses an LCD (Liquid Crystal Dis-
play) panel. This very sophisticated panel contains 786,432
(PG-A10X) / 480,000 (PG-A10S) pixels (

× RGB) TFTs (Thin

Film Transistors). As with any high technology electronic
equipment such as large screen TVs, video systems and
video cameras, there are certain acceptable tolerances that
the equipment must conform to.

This unit has some inactive pixels within acceptable toler-
ances which may result in inactive dots on the picture screen.
This will not affect the picture quality or the life expectancy
of the unit.

Specifications are subject to change without notice.