Sharp MX-M623U / MX-M753U (serv.man7) Service Manual ▷ View online
MX-M753N MX-FN14 7 – 5
8)
Remove the spanner stored inside of the front cabinet upper.
9)
Turn the bolt with the removed spanner so that the guide pin is
in the specified range of the scale.
in the specified range of the scale.
(At that time, lift the finisher a little, and the bolt can be turned
manually.)
manually.)
10) After completion of the adjustment, tighten the caster fixing
screws (8 pcs.).
11) Check to insure that the intervals at the upper and the lower
sides of the main unit and the finisher are even.
12) Attach the foot covers, and tighten the fixing screws.
13) Install the front cover lower, and fix it with the fixing screw.
MX-M753N MX-FN14 7 – 6
14) Attach the front cover upper, tighten the screw, and attach the
clip. Close the front cover upper.
E. Attach the staple position label.
Attach the staple position label as shown in the figure.
F. Connect the finisher connector
1)
Remove the connector cover fixing screw for connection of the
finisher joint harness connector, and remove the connector
cover.
finisher joint harness connector, and remove the connector
cover.
2)
Connect the finisher relay harness connector to the main unit
connector, and tighten the screw on the connector to fix.
connector, and tighten the screw on the connector to fix.
3)
Install the clamp to the finisher, and pass the cable.
G. Connect the power cord
1)
Connect the power cord to the finisher.
1
2
3
MX-M753N MX-FN14 7 – 7
H. Turn on the power of the main unit
1)
Insert the power plug of the main unit into the power outlet.
2)
Open the front cabinet.
Turn ON the power switch in the front cabinet of the main unit.
Turn ON the power switch in the front cabinet of the main unit.
3)
Turn ON the power switch on the operation panel.
ON
MX-M753N MX-PN10 8 – 1
MX-M753N
Service Manual
[8] MX-PN10
1. Unpacking
A. Removal of the interface punch unit
B. Removal of the tape and fixing member
1)
Remove the tape and fixing member.
C. Check the packed items
1)
Check that all the items are included in the package.
NOTE: Be sure to use the punch label bundled with the finisher.,
and never use the punch label bundled with the punch unit.
2. Installation
<Note before installation>
* Before starting installation, check to insure that the data lamp on
* Before starting installation, check to insure that the data lamp on
the operation panel is not on or blinking.
A. Turn off the power of the main unit
1)
Turn OFF the power switch on the operation panel.
2)
Open the front cabinet.
Turn OFF the power switch in the front cabinet of the main unit.
Turn OFF the power switch in the front cabinet of the main unit.
3)
Disconnect the power plug of the main unit from the power out-
let.
let.
B. Removal of the external outfit
1)
Open the front cover upper of the finisher.
1
Fixing pin
1 pc.
2
Punch dust sensor unit
1 pc.
3
Dust box
1 pc.
4
Screw A
1 pc.
5
Screw B
1 pc.
6
Punch position label
2 pc.
7
Punch jam process guidance label
1 pc.
1
2
3
4
5
6
7
OFF
Click on the first or last page to see other MX-M623U / MX-M753U (serv.man7) service manuals if exist.