Sharp MX-BMX1 (serv.man15) Service Manual / Technical Bulletin ▷ View online
7
52
REMARKS
Maintaining Your Machines
Never attempt any maintenance function that is not specifically described in this
Booklet Maker
Oil Clinchers and Stapler heads
Stapling area,
view from infeed
close-up of clincher
lever
close-up of clincher
lever
close-up of
clincher
A
B
B
The clinchers must be oiled every 20 000 stapling cycles to avoid mechanical breakdown.
7
53
Open the top cover.
Put a couple of drops of oil in each clincher (A).
To get rid of excessive oil:
Push down clincher (B) lever a couple of times.
Push down clincher lever (B) while wiping of excessive oil with a dry cloth.
Run a few blank booklets.
When clinchers have beed lubricated, the error message must be reset:
Switch of the main power switch on the machine.
Press and hold the two innermost buttons on the UI, buttons 2 and 3.
Switch on the main power switch and release the buttons after 2 seconds.
Remove the Stapler heads according to section 1, BASICS Check staples, Staple cartridge
and Stapler head.
Put a couple of drops of oil on each side of the drive post (C).
Cycle the Stapler head a couple of times before installing it again.
breakdown.
C
Display