DOWNLOAD Sharp AR-CF1 (serv.man7) Service Manual ↓ Size: 2.49 MB | Pages: 58 in PDF or view online for FREE

[5]

[4]

[7]

[6]

[8]

[6]

[6]

4) Turn the gear [4] in the direction of the ar-

row, and move the punch unit section [5] to
the front side.

5) Remove the three screws [5], and remove

the sensor mount (upper) [7]. Then, remove
the connector on the photosensor PCB.

[10]

[9]

[11]

[13]

[12]

7) Turn the gear [12] in the direction of the ar-

row, and move the punch unit section [13]
to the inner side.

6) Disconnect the connector [9] and remove the

screw [10], and remove the horizontal reg-
istration sensor [11].

11) Disconnect the connector [19] on the LED

PCB.

[15]

[14]

[15]

[17]

[16]

10) Lift up the front side of the punch unit sec-

tion [18] first, then move in the direction of
the arrow to remove the punch unit section
[18].

8) Remove the tie wrap with lock [14] while

holding its claw between your fingers. (The
tie wrap must be removed without being cut.)

9) Disconnect the three connectors [15] and

remove the screw [16], and remove the har-
ness guide [17].

[18]

[19]

12) Remove the slide shaft support [20], the sen-

sor mount (lower) [21] and the puncher knob
[22] from the punch unit section.

The slide shaft support [20] is not attached
to punch unit sections that are currently set
as consumable parts.
When replacing the punch unit section, be
sure to attach the slide shaft support that
was in use beforehand.
If you forget to attach the slide shaft
support, the machine may malfunction.

[20]

[22]

[21]