DOWNLOAD Sharp AR-337 (serv.man8) Service Manual ↓ Size: 4.65 MB | Pages: 127 in PDF or view online for FREE

  Misfeed removal

●

Confirm that the misfeed display is cleared.

NOTE:
If the optional finishers (AR-FN1N, AR-FN2) is fitted, please refer to
chapter 7 Optional Equipment for additional misfeed removal help.

If the misfed paper is in the duplex module or the section below the
exit area:

1

Open the paper guide, turn roller rotating knob 

D

 in the

direction of the arrow and remove the misfed paper.
Close the paper guide.

2

Remove any misfed paper from the duplex module.

●

Be careful not to tear the misfed paper during removal.

Paper
guide

Roller rotating knob  D

Paper feed area open/close lever

3

Remove the misfed paper from the section below the exit area.

If the misfed paper is in the right side of the duplex module:

●

Hold the handle and gently open the cover.

●

If any paper is set in the bypass tray, remove the paper and close
the bypass tray  before opening the right side cover.

●

Open the paper feed area open/close lever in the direction of the
arrow and remove the misfed paper.

●

Confirm that the misfeed display is cleared.

  Misfeed removal

When the message “

”

appears in the message display, service by an authorised Sharp
Service Technician will be required soon. Contact your Service Centre
as soon as possible.

  Maintenance required

  Troubleshooting

Always check the message display whenever the copier stops or
operation is not possible. The messages will give you easy-to-follow
directions. If the messages do not give specific  instructions, check the
list below.

Copier does not operate.

Copies are too dark or too
light.

Blank copies.

Copies smear if rubbed.

Copy size is different from
the selected paper size.

Paper misfeeds frequently.

●

Copier plugged in?

●

Power switch on?

●

Copy density properly adjusted?

●

Is the original placed face up in the
document feeder tray or face down
on the document glass?

●

Paper too heavy?

●

Paper damp?

●

Paper size indicator properly set?

●

Non-standard paper used?

●

Is paper properly installed?

●

Pieces of paper inside copier?

●

Paper curled or damp?

Plug the copier into a grounded outlet.

Turn the power switch on.

See page 2-16.

Place the original face up in the
document feeder tray or face down on
the document glass.

Use copy paper within the specified
range. See page 4-2.

Replace with dry copy paper. Be sure
to store copy paper in a dry location.

When changing the copy paper size in
a tray, be sure to adjust the paper size
indicator. See page 4-4.

Use standard paper.
If using special papers, feed the paper
through the bypass tray.

See pages 2-14 and 4-2.

Remove all pieces of misfed paper.
See page 5-2.

Store copy paper flat in the wrapper in
a dry location. See page 4-8.

Problem

Solution