DOWNLOAD Sharp AR-285 (serv.man35) Service Manual ↓ Size: 1.49 MB | Pages: 58 in PDF or view online for FREE

                                      

Page

●

7-2

●

7-3

●  

Part names

7-3

●  

Offset stack

7-4

●  

Sort and group

7-5

●  

Staple sort

7-6

●  

Staple cartridge replacement

7-10

●  

Staple jam removal

7-12

●  

Misfeed removal

7-14

●  

Specifications

7-19

●

7-20

●  

Part names

7-20

●  

Specifications

7-20

●  

Loading copy paper

7-21

●  

Misfeed removal

7-22

●

7-24

●  

Part names

7-24

●  

Specifications

7-24

●  

Loading copy paper

7-25

●  

Misfeed removal

7-26

This chapter describes operating instructions for
the Finisher (AR-FN1), Large Capacity Tray
(AR-LC1), and Stand/500-sheet Paper Drawer
(AR-DE1).

The options which are available for this copier are shown below.

System configuration

Large capacity tray (AR-LC1)

Finisher (AR-FN1)

Stand/500-sheet paper drawer (AR-DE1)

500-sheet paper drawer (AR-CS1)

Exit tray
(AR-TE1)

In the AR-280, the duplex module
(AR-DU1) is provided as an
optional component.

The copier has two different finisher modes: one sorts copies into
sets matching the sequence of the originals and the second groups
copies by original. When the optional finisher (AR-FN1) is installed,
the copier can automatically staple the sorted copies. Each collated
set of copies or group of copies can be stacked offset from the
previous set.

Finisher (AR-FN1)

Finisher release lever

Top tray

Second tray 
(not used in the copy mode)

Stapler unit

Paper transport area cover

Paper feed area cover

Top cover

Offset tray

When copying onto size A3 (11” x 17”) 
paper, lower the metal support located at 
the tip of the offset tray.

●

The top tray and second tray are each furnished with an extendable component, which is to be used when copying
onto size A3 (11” x 17”) paper.

1

2

3

1

1

1

1

2

1

1

1

2

3

1

Finisher (AR-FN1)

OUTPUT

TOP TRAY

OFFSET

SO

OFFSET

TRAY

In the initial setting, the offset tray will move from side to side so that
each copy set is offset by approximately 30 mm (1.2 inch).
When the offset stack function is disabled, the offset tray will not
move from side to side.
The offset stack function can be enabled or disabled by pressing  the
OUTPUT key and then the “OFFSET” check mark box on the touch
panel.
When the STAPLE SORT mode is selected, the offset stack function
will be disabled.
The top tray cannot be used to offset copies.
To select the top tray, press the “TOP TRAY” key on the touch panel.