Sharp AL-2020 (serv.man2) Service Manual ▷ View online
AL-2040 DISASSEMBLY AND ASSEMBLY 8 - 11
18) Remove each pawl, and remove the paper exit tray.
19) Remove two screws and remove the fusing connector.
20) Remove five screws and the connector, and lift the intermedi-
ate frame unit to remove.
21) Remove the screw and the E-ring, and remove the PS semi-
circular earth plate and the PS roller unit.
22) Remove the E-ring and remove the spring clutch from the PS
roller unit.
23) Remove three screws and remove the TC front paper guide.
2)
1)
3)
2)
2)
3)
4)
1)
5)
4)
4)
1)
2)
3)
PS roller unit
PS semi-circuler
earth plate
5)
4)
4)
1)
2)
3)
PS semi-circular
earth plate
earth plate
Use grease of
Floil FG40H
only to apply to
this section.
Floil FG40H
only to apply to
this section.
1)
2)
AL-2040 DISASSEMBLY AND ASSEMBLY 8 - 12
24) Remove the screw and the connector, and remove the PPD1
sensor PWB.
25) Remove two E-rings and remove the paper feed roller.
26) Remove three E-rings and remove the clutch unit.
C. Assembly procedure
For assembly, reverse the disassembly procedure.
6. Manual paper feed section
A. List
B. Disassembly procedure
Multi unit
1) Remove the screw and remove the multi upper cover.
1)
2)
4)
5)
1)
2)
3)
4)
Back
Front
Clutch unit
Paper feed
roller
roller
No.
Part name Ref.
1
Manual transport roller
2
Cassette detection switch
3
PPD1 sensor PWB
4
Side door detection unit
2)
1)
AL-2040 DISASSEMBLY AND ASSEMBLY 8 - 13
2) Remove the screw and remove the side door detection unit.
3) Remove three screws and remove the multi paper feed upper
frame.
4) Remove two screws and remove the multi feed bracket unit
from the multi paper feed upper frame.
5) Remove three E-rings and remove the manual paper feed
roller B9.
1)
2)
Back
Wire treatment
1)
2)
1)
2)
AL-2040 DISASSEMBLY AND ASSEMBLY 8 - 14
6) Remove the pick-up roller.
7) Cut the binding band and remove the multi paper feed sole-
noid.
C. Assembly procedure
For assembly, reverse the disassembly procedure.
D. Pressure plate holder attachment
1) Attach the pressure plate holder so that the resin section is not
covered with the seal M1-N.
7. Rear frame section
A. List
B. Disassembly procedure
1) Remove four screws, and remove the rear cabinet and the rear
cabinet cover.
2)
1)
1)
2)
3)
Multi paper feed
solenoid
solenoid
No.
Part name Ref.
1
Scanner motor
2
Main motor
3
Exhaust fan motor
4
NIC PWB
5
Main PWB
Pressure plate
holder
holder
Seal M1-N
Attachment
reference
reference
Attachment
reference
reference
1)
1)
2)
2)
1)
Click on the first or last page to see other AL-2020 (serv.man2) service manuals if exist.