Sharp LL-P202V (serv.man2) Service Manual ▷ View online
LL-P202V/S242A DISASSEMBLY AND ASSEMBLY 4 - 17
8. FRONT CAB+TOUTH PANEL UNIT
■LL-P202V
1) Remove the Rear cabinet.
2) Remove the five connectors on the Main PWB and remove the five screws (M3x6 2 pieces at the left side of the following image, M3x4 3
pieces at the right side of the following image)
3) Turn the Main PWB and disconnect the two connectors at the rear side of the Main PWB.
LL-P202V/S242A DISASSEMBLY AND ASSEMBLY 4 - 18
4）Unhook the ten pawls.
5）Remove the Front cab+Touch panel unit.
LL-P202V/S242A DISASSEMBLY AND ASSEMBLY 4 - 19
■LL-S242A
1) Remove the center angle.
2) Remove the five connectors on the Main PWB and remove the five screws (M3x6 SW+W).
3) Turn the Main PWB and disconnect the two connectors at the rear side of the Main PWB. Then, remove the Main PWB.
<Caution>
・
When the connectors are disconnected, be careful not to putting a load on the FPC by pulling it.
・
When the connector is connected, insert the connector firmly and fit the tabs with the channels of the connector.
LL-P202V/S242A DISASSEMBLY AND ASSEMBLY 4 - 20
4) Unhook the sixteen pawls and remove the angle for connecting the PWB.
Click on the first or last page to see other LL-P202V (serv.man2) service manuals if exist.