Sharp RZ-X660 (serv.man3) Service Manual ▷ View online
59
Boot Screen
In this section, it will display the available devices on your system for you to
configure the boot settings and the boot priority.
Fast Boot
Fast Boot minimizes your computer’s boot time. There are three configuration
options: [Disabled], [Fast] and [Ultra Fast]. The default value is [Disabled].
Please refer to below descriptions for the details of these three options:
[Disabled] - Disable Fast Boot.
[Fast] - The only restriction is you may not boot by using an USB flash drive.
[Ultra Fast] - There are a few restrictions.
1. Only supports Windows® 8 64-bit UEFI operating system.
2. You will not be able to enter BIOS Setup (Clear CMOS or run utility in
2. You will not be able to enter BIOS Setup (Clear CMOS or run utility in
Widows® to enter BIOS Setup).
3. If you are using an external graphics card, the VBIOS must support UEFI
GOP in order to boot.
Boot From Onboard LAN
Use this item to enable or disable the Boot From Onboard LAN feature.
Setup Prompt Timeout
This shows the number of seconds to wait for setup activation key.
Bootup Num-Lock
If this item is set to [On], it will automatically activate the Numeric Lock
function after boot-up.
60
Boot Beep
Select whether the Boot Beep should be turned on or off when the system
boots up. Please note that a buzzer is needed.
Full Screen Logo
Use this item to enable or disable OEM Logo. The default value is [Enabled].
CSM (Compatibility Support Module)
CSM
Enable to launch the Compatibility Support Module. Please do not disable
unless you’re running a WHCK test. If you are using Windows® 8 64-bit and all
of your devices support UEFI, you may also disable CSM for faster boot speed.
61
Exit Screen
Save Changes and Exit
When you select this option, it will pop-out the following message, “Save
configuration changes and exit setup?” Select [OK] to save the changes and
exit the UEFI SETUP UTILITY.
Discard Changes and Exit
When you select this option, it will pop-out the following message, “Discard
changes and exit setup?” Select [OK] to exit the UEFI SETUP UTILITY without
saving any changes.
Discard Changes
When you select this option, it will pop-out the following message, “Discard
changes?” Select [OK] to discard all changes.
Load UEFI Defaults
Load UEFI default values for all the setup questions. F9 key can be used for this
operation.
Launch EFI Shell from filesystem device
Attempts to Launch EFI Shell application (Shell64.efi) from one of the available
filesystem devices.
62
PCB OVERVIEW
System Main B/D
System Block Diagram
Click on the first or last page to see other RZ-X660 (serv.man3) service manuals if exist.