DOWNLOAD Sharp DV-NC100H (serv.man8) Service Manual ↓ Size: 1.52 MB | Pages: 32 in PDF or view online for FREE

–Check if the AC power cord is properly connected.

–Check if the TV is switched on.
–Check if the cable is connected to the correct device.

(See “Connecting to a TV or a stereo TV”)

–Sometimes a small amount of picture distortion may appear.

This is not a malfunction.

–Connect VCR/DVD directly to the TV.

–Make sure the disc is compatible with the VCR/DVD.

–Adjust the volume.
–Check that the speakers are connected correctly.
–Check if the cable is connected to the correct device.

(See “Connecting to a TV or a stereo TV”)

–Check the digital connections.
–Check if the audio format of the selected audio language matches your

receiver capabilities.

–Use a COAXIAL DIGITAL AUDIO OUT jack when outputting the DTS audio.

–Check the disc for fingerprints/scratches and 

clean with a soft cloth wiping from centre to edge.

–Ensure the disc label is facing up.
–Check if the disc is defective by trying another disc.
–Handle a disc with special care so that it does not have fingerprints, 

scraches or dusts on its surface.

–Reset the VCR/DVD by switching the VCR/DVD off, then on again.

–Aim the remote control directly at the sensor on the front of the VCR/DVD.

–Reduce the distance to the VCR/DVD.
–Replace the batteries in the remote control.
–Re-insert the batteries with their polarities (+/– signs) as indicated.

–To completely reset the VCR/DVD, unplug the AC 

cord from the AC outlet for 5-10 seconds.

–Operations may not be permitted by the disc.

Refer to the instructions of  the disc.

–Use a commonly available cleaning CD/DVD to clean the lens 

before sending the VCR/DVD for repair.

–Make sure the tape has a erase-prevention tab.
–Make sure this VCR/DVD is in VCR mode.

–Make sure the start and the stop recording times are set correctly.
–Make sure the tape has a erase-prevention tab.
–Make sure the clock is set.
–This VCR/DVD may not perform or continue a timer recording if the power

fails for more than 1 hour.

–To enable quick play mechanism, the motor will rotate for about five 

minutes. This is normal.

–Insert a tape with window side up and the erase-prevention tab facing you.
–Gently push the centre of the tape when putting into the cassette 

compartment.

–Make sure the power plug is completely connected to a power 

outlet.

– 29 –

EN

If the VCR/DVD does not perform properly when operated as instructed in this Operation Manual, check the VCR/DVD, con-
sulting the following checklist.

• Some functions are not available in specific modes, but this is not a malfunction. Read the description in this Operation

Manual for details on correct operations.

• Playback from a desired track and random playback are not available during programme playback.
• Some functions are prohibited on some discs.

If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

The following conditions do not always denote trouble. Therefore, perform the checks described below before calling for service. If the
problem cannot be corrected by the use of this guide, remove the main plugs from the wall socket, and contact the dealer or supplier
from whom the unit was purchased in order to obtain service. Where this is not possible please visit our web-site
www.sharp.co.uk/customersupport.
Customers without Internet access may telephone 08705 274277 during office hours (or (01) 6760648 if telephoning from Ireland),

Certain replacement parts and accessories may be obtained from our main parts distributor, who can be contacted on the following
numbers:

WILLOW VALE ELECTRONICS LTD.:

0121 766 5414

In the unlikely event of this equipment requiring repair during the guarantee period, you will need to provide proof of the date of
purchase to the repairing company. Please keep your invoice or receipt, which is supplied at the time of purchase.

WARNING
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the
system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair.

H9741BD(EN).qx4  04.5.12  16:03  Page 29

– 30 –

EN

DVD Player with Video Cassette recorder

NUMBER OF VIDEO HEADS
4

VIDEO SIGNAL STANDARD
PAL colour system

AUDIO RECORDING SYSTEM
1 Stationary head for liner audio
2 Rotary heads for Hi-Fi stereo

CHANNEL COVERAGE
IRA - E69

TIMER BACKUP
60 minutes

DISCS (PLAYBACK COMPATIBILITY)
DVD Video / Audio CD / Video CD / CD-RW / R
DVD-RW / R, DVD+RW / R

FREQUENCY RESPONSE
DVD (linear sound) : 20 Hz to 20 kHz (sample rate: 48 kHz)

20 Hz to 44 kHz (sample rate: 96 kHz)

CD :

20 Hz to 20 kHz

SIGNAL-TO-NOISE RATIO (S/N RATIO)
CD :

110 dB (JEITA)

DYNAMIC RANGE
DVD (linear sound) : 90 dB
CD :

90 dB (JEITA)

TOTAL DISTORTION FACTOR
DVD :

1KHz       0.008% (JEITA)

CD :

1KHz       0.008% (JEITA)

WOW AND FLUTTER
Below the measurement limitation (+/-0.001% W PEAK)
(JEITA)
CONNECTIONS
Front panel:

Video input

RCA connector [ 1

Audio input

RCA connector [ 2

Rear panel:

Audio/Video Output/Input 21-pin Scart jack [ 2
S-Video output

Mini DIN 4-pin jack (75 ohm)

Analog audio output

RCA connectors [ 2 (one left
channel, one right channel) 
2 Vrms (47 kilo-ohm)

Coaxial digital audio output One pin jack, 500mVpp (75 ohm)

POWER SOURCE
220-240 V ~ +/- 10%, 50Hz +/- 0.5%

POWER CONSUMPTION
30W (standby: 5W)

OPERATING TEMPERATURE
5°C to 40°C

DIMENSIONS
W: 435mm   H: 94mm   D: 233mm

WEIGHT
Approx 3.2kg

• Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits,

ammonia or abrasives.

• When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the centre out. Do not wipe in a circular

motion.

• Do not use solvents such as benzine, thinner, commercially available cleaners, detergent, abrasive cleaning agents or

antistatic spray intended for analogue records.

• If the VCR/DVD still does not perform properly when it is operated while referring to the relevant sections and to “TROU-

BLESHOOTING GUIDE” in this Operation Manual, the laser optical pickup unit may be dirty. Consult your dealer or an
authorised Service Centre for inspection and cleaning of the laser optical pickup unit.

• Use discs which have the following logos on them. (Optical audio digital discs.)

• Handle the discs so that fingerprints and dust do not adhere to the surfaces of the discs.
• Always store the disc in its protective case when it is not used.

• Used up batteries do not belong in the dust bin.
• You can dispose of them at a collection point for used up batteries or special waste. Contact your council for details.

Recordable

Recordable

ReWritable

ReWritable

• Designs and specifications are subject to change without notice.
• If there is a discrepancy between languages, the default language will be English.

H9741BD(EN).qx4  04.5.12  16:03  Page 30

– 31 –

EN

Sharp Electronics (UK) Ltd. (“Sharp”) guarantees to provide for the repair, or at its option the
replacement, of this product subject to the conditions listed below:-

1. This guarantee shall only apply to faults which are due to inferior workmanship or materials. It does

not cover faults or damage caused by accident, misuse, fair wear and tear, neglect, tampering
with the product, or repair other than by a Service Facility appointed by Sharp.

2. As this product is intended for private domestic use only, the guarantee will not apply if the product

is used in the course of a business, trade or profession.

3. To benefit from this guarantee, any fault which occurs must be notified to Sharp, or its appointed

Service Facility within one year from the date this product was purchased. Proof of purchase must
be provided.

4. The guarantee does not cover carriage costs.

5. In the unlikely event of this product requiring repair, please contact the supplier from whom it was

purchased. Where this is not possible, please contact the Sharp Customer Information Centre on
the telephone number given below.

6. No person has any authority to vary the terms or conditions of this guarantee.

7. This guarantee is offered as an additional benefit to your statutory rights, and does not affect these

rights in any way.

If you have any difficulty operating this product, or would like information on other Sharp products,
please telephone the Sharp Customer Information Centre on the number given below.

 Sharp Customer Information Centre - Telephone 08705 274277

(or (01) 676 0648 if telephoning from Ireland)

0201

H9741BD(EN).qx4  04.5.12  16:03  Page 31

1VMN20164

H9741BD 

★★★★★

9HS1VMN20164

Sharp house, Thorp Road, Newton Heath

Manchester M40 5BE

H9741BD(EN).qx4  04.5.12  16:03  Page 32