Sharp XL-MP8H (serv.man2) User Manual / Operation Manual ▷ View online
05/6/10
XL-MP8H(E)2.fm
22
TINSZA056SJZZ
XL-MP8H
Refe
rences
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
CD player
Tuner
Remote control
Symptom
Possible cause
z
The clock is not set to the
correct time.
correct time.
z
Did a power failure occur? Reset
the clock. (Refer to page 10.)
the clock. (Refer to page 10.)
z
When a button is pressed,
the unit does not respond.
the unit does not respond.
z
Set the unit to the power stand-
by mode and then turn it back on.
by mode and then turn it back on.
z
If the unit still malfunctions, reset
it. (Refer to page 23.)
it. (Refer to page 23.)
z
No sound is heard.
z
Is the volume level set to "MIN"?
z
Are the headphones connected?
z
Are the speaker wires discon-
nected?
nected?
Symptom
Possible cause
z
Playback does not start.
z
Is the disc loaded upside down?
z
Playback stops in the mid-
dle or is not performed
properly.
dle or is not performed
properly.
z
Does the disc satisfy the stan-
dards?
dards?
z
Is the disc distorted or
scratched?
scratched?
z
Playback sounds are
skipped, or stopped in the
middle of a track.
skipped, or stopped in the
middle of a track.
z
Is the unit located near excessive
vibrations?
vibrations?
z
Is the disc very dirty?
z
Has condensation formed inside
the unit?
the unit?
Symptom
Possible cause
z
The radio makes unusual
noises continuously.
noises continuously.
z
Is the unit placed near the TV or
computer?
computer?
z
Is the FM/AM loop aerial placed
properly? Move the aerial away
from the AC power lead if located
nearby.
properly? Move the aerial away
from the AC power lead if located
nearby.
Symptom
Possible cause
z
The remote control does
not operate.
not operate.
z
Is the AC power lead of the unit
plugged in?
plugged in?
z
Is the battery polarity correct?
z
Are the batteries dead?
z
Is the distance or angle incor-
rect?
rect?
z
Does the remote control sensor
receive strong light?
receive strong light?
7
05/6/10
XL-MP8H(E)2.fm
23
TINSZA056SJZZ
XL-MP8H
Refe
rences
Troubleshooting chart (continued)
If trouble occurs
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
If such a problem occurs, do the following:
1
1
Set the unit to the stand-by mode and turn the power on again.
2
If the unit is not restored in the previous operation, unplug and
plug in the unit, and then turn the power on.
plug in the unit, and then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory by
resetting it.
If neither operation above restores the unit, clear all the memory by
resetting it.
Clearing all the memory (reset)
1
Press the ON/STAND-BY button to enter the power stand-by
mode.
mode.
2
Whilst pressing down the FUNCTION button and the CLEAR
button, press the ON/STAND-BY button until "CL" appears.
button, press the ON/STAND-BY button until "CL" appears.
Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.
Condensation
Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet (CD
pickup, etc.) or on the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc in the unit until normal playback is
possible (about 1 hour). Wipe off any condensation on the transmit-
ter with a soft cloth before operating the unit.
humid environment may cause condensation inside the cabinet (CD
pickup, etc.) or on the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on with no disc in the unit until normal playback is
possible (about 1 hour). Wipe off any condensation on the transmit-
ter with a soft cloth before operating the unit.
Maintenance
Cleaning the CD pickup lens
Poor performance during CD playback (skipping or jumping) can be
caused by a dirty or contaminated CD laser pick up lens. If this hap-
pens then the use of a commercially available CD lens cleaning
discs may restore normal operation. Contact your supplier or local
CD software dealer to obtain CD lens cleaning discs. Ensure all
included instructions/documentation are carefully followed.
caused by a dirty or contaminated CD laser pick up lens. If this hap-
pens then the use of a commercially available CD lens cleaning
discs may restore normal operation. Contact your supplier or local
CD software dealer to obtain CD lens cleaning discs. Ensure all
included instructions/documentation are carefully followed.
Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.
solution, then with a dry cloth.
Caution:
z
Do not use chemicals for cleaning (petrol, paint thinner, etc.). It
may damage the cabinet finish.
may damage the cabinet finish.
z
Do not apply oil to the inside of the unit. It may cause malfunc-
tions.
tions.
Care of discs
Compact discs are fairly resistant to damage, however mistracking
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
tion and player.
can occur due to an accumulation of dirt on the disc surface. Follow
the guidelines below for maximum enjoyment from your CD collec-
tion and player.
z
Do not write on either side of the disc, particularly the non-label
side from which signals are read. Do not mark this surface.
side from which signals are read. Do not mark this surface.
z
Keep your discs away from direct sunlight, heat, and excessive
moisture.
moisture.
z
Always hold the CDs by the edges. Fingerprints, dirt, or water on
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.
the CDs can cause noise or mistracking. If a CD is dirty or does
not play properly, clean it with a soft, dry cloth, wiping straight out
from the centre, along the radius.
NO
YES
Correct
Correct
05/6/10
XL-MP8H(E)2.fm
24
TINSZA056SJZZ
XL-MP8H
Refe
rences
Specifications
As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification fig-
ures indicated are nominal values of production units. There may be
some deviations from these values in individual units.
the right to make design and specification changes for product
improvement without prior notice. The performance specification fig-
ures indicated are nominal values of production units. There may be
some deviations from these values in individual units.
General
Amplifier
Tuner
CD player
Speaker
Power source
AC 230 V, 50 Hz
Power
consumption
consumption
Power on: 25 W
Power stand-by: 0.9 W
Dimensions
Width: 100 mm (3-15/16")
Height: 205 mm (8-1/16")
Depth: 240 mm (9-7/16")
Height: 205 mm (8-1/16")
Depth: 240 mm (9-7/16")
Weight
2.1 kg (4.6 lbs.)
Output power
RMS: 10 W (5 W + 5 W) (10 % T.H.D.)
Output terminals
Speakers: 4 ohms
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
(recommended: 32 ohms)
Line output: 2 k ohms
Input terminals
Line input: 47 k ohms
Frequency range
FM: 87.5 - 108.0 MHz
AM: 522 - 1,620 kHz
Type
Compact disc player
Signal readout
Non-contact, 3-beam semiconductor laser
pickup
pickup
D/A converter
1-bit D/A converter
Frequency
response
response
20 - 20,000 Hz
Dynamic range
90 dB (1 kHz)
Type
8 cm (3-1/8") full-range speaker
Maximum input
power
power
10 W
Rated input power
5 W
Impedance
4 ohms
Dimensions
Width: 100 mm (3-15/16")
Height: 205 mm (8-1/16")
Depth: 193 mm (7-5/8")
Height: 205 mm (8-1/16")
Depth: 193 mm (7-5/8")
Weight
1.2 kg (2.6 lbs.)/each
7
TERMS OF GUARANTEE
Sharp Electronics (UK) Ltd. (“Sharp”) guarantees to provide for the repair, or at its option the replace-
ment, of this product subject to the conditions listed below:-
ment, of this product subject to the conditions listed below:-
1. This guarantee shall only apply to faults which are due to inferior workmanship or materials. It does
not cover faults or damage caused by accident, misuse, fair wear and tear, neglect, tampering with
the product, or repair other than by a Service Facility appointed by Sharp.
the product, or repair other than by a Service Facility appointed by Sharp.
2. As this product is intended for private domestic use only, the guarantee will not apply if the product
is used in the course of a business, trade or profession.
3. To benefit from this guarantee, any fault which occurs must be notified to Sharp, or its appointed
Service Facility within one year from the date this product was purchased. Proof of purchase must
be provided.
be provided.
4. The guarantee does not cover carriage costs, audio tapes, compact discs or batteries.
5. In the unlikely event of this product requiring repair, please contact the supplier from whom it was
purchased. Where this is not possible, please contact the Sharp Customer Information Centre on
the telephone number given below.
the telephone number given below.
6. No person has any authority to vary the terms or conditions of this guarantee.
7. This guarantee is offered as an additional benefit to your statutory rights, and does not affect these
rights in any way.
If you have any difficulty operating this product, or would like information on other Sharp products,
please telephone the Sharp Customer Information Centre on the number given below.
please telephone the Sharp Customer Information Centre on the number given below.
Sharp Customer Information Centre - Telephone 08705 274277
(or (01) 676 0648 if telephoning from Ireland)
0312
SHARP ELECTRONICS (U.K.) LTD.
Sharp House, Thorp Road, Newton Heath, Manchester, M40 5BE
SHARP CORPORATION
0401_A5
05/6/10
XL-MP8H(E)_BACK.fm
TINSZA056SJZZ
TINSZA056SJZZ
05F N YA 1
05F N YA 1
