DOWNLOAD Sharp AY-X127E Service Manual ↓ Size: 1.99 MB | Pages: 45 in PDF or view online for FREE

38

18. Turn the cap area of the drain hose counterclockwise,

and remove it from the drain pan.

21. Move the evaporator to the up, and release it from one

projection of cabinet.  Free the evaporator, and pull down
the cross-flow fan and motor toward you. Remove them
together. (If it is tried to remove the fan alone, it will
damage the inner surface of the metal to prevent removing
the fan.)

During installation, turn the drain hose to the state of the
“engagement position”.
After reinstallation, verify that it is securely fastened.

19. Pull down the drain pan toward you for removal.

20. Remove two fastening screws of the side cover L.

Drain hose

Drain pan

Groove

Projection

To disconned

To reconnect

22. Loosen the fan fastening screw, and remove the fan.

39

a. When inserting the shaft of the cross-flow fan into the

metal, take care to prevent injuring the inner surface
of the metal.

b. Before fastening the motor shaft and fan, insert the

shaft into contact with the fan boss.

How to remove the electric control box.
1. Remove the fastening screw of the 4 poles terminal

board.

Motor shaft

Fan

Fan boss

23. To remove the evaporator, remove the tube holder on

the rear side of the cabinet, pull the side cover L of left
side with the side cover R of right side toward yourself
and lift it up, and remove it from cabinet, pulling it toward
you.

3.  Remove the receiver unit.(Press and spread the upper

hook, and the receiver unit will be ready for removal.)

2. Remove the cord holder fastening screw of the power

supply cord.

40

4. Remove the terminal board fastening screw of the terminal

board holder.

5. Remove the thermostat holder from the control box.

6. Remove the fastening screw of the board.

7. Pull out the board.

Drain pan and related
How to remove the louver motor.
Remove two screws which fasten the louver motor.

How to remove the horizontal adjustment louver
Slightly fall down the hinge area, deflect the louver, and
remove it at one place. Remove the shaft from each of the
left and right sides.

How to remove the side clamp assembly
Left the edge of the drain pan to the arrow-marked
direction and ditach the side clamp assembly.

Hinge area

41

2. Remove the control box cover.

3. Remove two screws which are fixing right side of the

front panel.
And disconnect the wiring from the terminal board.

6. Take off the three hooks of back side of the front panel.

And pull it toward you.

1. Remove one screw which is fixing the control box cover.

4. Remove two screws which are fixing left side of the front

panel.

5. Remove one screw which is fixing front part of the front

panel.
(BLACK COLOR)