DOWNLOAD Sharp AE-XM18CR (serv.man16) Service Manual ↓ Size: 1.37 MB | Pages: 14 in PDF or view online for FREE

63

9-1.Cut off 2 fixing bands.

2During reassembly, fix them by fixing bands as same
certainly.

9-2.Cut off 3 fixing bands.

During reassembly, fix them by fixing bands as same
certainly.

10. Remove 2 thermistors of the evaporator and the pipe.

11.Remove 4 conectors.

CN1

CN6

CN3

CN2

12. Remove the thermistor holder from the evaporator.

13.Remove the display from the drain pan.

14. Remove the screw fixing the pipe holder.

15. Remove 3 screws fixing the control box,and remove

the control box.

16. Remove a screw fixing the drain pan.

64

17. Pull the drain pan toward you.

18. Remove the drain cover from the evaporator.

19. Remove 4 screws fixing the evaporator.

20. Remove the evaporator from the cabinet.

21. Remove 3 screws fixing the motor cover, and pull up

the fan.

22.Loose a screw fixing fan.

65

[Cautionary points for assembling the fan]
a. When inserting the motor shaft into the metal fan

boss, take care to prevent injuring the inner surface of
the metal fan boss.

b. Before fastening the motor shaft and fan, insert the

motor shaft into the metal fan boss until it stops.

1. Push the center of display cover from the back.
2. Slide the display cover to the right.

2. After the left half is inseted completely, press the

display cover and snap in the 2 or 3 hooks on the
right.

1. Remove the photo detector unit.

(Press and spread the upper hook, and the photo
detector unit will be ready for removal.)

2. Remove the screw fixing the terminal board.

Fan motor

Motor shaft

Fan boss

Cross flow fan

1

2

3. Remove 2 screws fixing the board (transformer).

1. Slide the left end of the display cover through 2 or 3

hooks on the front panel along the guide from the
center of the front panel.

2 hooks ..... AY-XPM7CR/9CR/12CR
3 hooks ..... AY-XM7CR/9CR/12CR

4. Remove 5 connectors. And cut off a fixing band.
< AY-XPM7CR/9CR/12CR only >

CN8

CN10

CN6

CN9

CN7

66

DUST  SENSOR

GAS  SENSOR

THERMISTOR

CN101 and CN102

5. Remove 2 connectors.
< AY-XPM7CR/9CR/12CR only >

6. Pull the board.

1. Remove 3 screws fixing motors.

2. Turn the cap area of the drain hose counterclockwise,

and remove it from the drain pan.
During installation, turn the drain hose to the state of
the “engagement position”.
After reinstallation, verify that it is securely fastened.

How to remove the horizontal louver
Slightly pull down the hinge area, deflect the louver, and
unhook it from the hinge. Remove the shaft from each of
the left and right sides.

Drain pan

Drain Hose

Groove

Projection

To disconned

To reconnect

1. Remove  the HIGH VOLTAGE UNIT.

(Press and spread the hook, and HI VOLTAGE will be
ready for removal.)

Remove the DUST SENSOR, the THERMISTOR, and the
GAS SENSOR.
(Press and spread the hook,and GAS SENSOR  will be
ready for removal)

display  board  unit2

1

2

The display board unit 2 is pushed in the direction of arrow
   1   .
And it is made to slide in the direction of arrow   2   , and
remove.