Panasonic TX-LR32S10 Service Manual ▷ View online
TX-LR32S10
9
4 Power LED Blinking Timing
1. Subject
Information of LED Flashing timing.
2. Contents
When an abnormality occurs, the protection circuit will operate and reset the unit to stand by mode. During this time, the
defective block can be identified by the number of blinking times of the Power LED on the front panel of the unit as follow:
defective block can be identified by the number of blinking times of the Power LED on the front panel of the unit as follow:
Blinking times
Contents
1
Inverter_SOS
3
SOS_3.3V over voltage protection
4
DTV_ 9V decreased / short circuit, main convertor stop detection.
5
Main_ 9V decreased
6
Sub_ 5V decreased
7
Sub_ 3.3V decreased
8
MAIN_ 3.3V decreased
9
Sound_ SOS
13
Emergency SOS
14
Audio PWM SOS
TX-LR32S10
10
5 Chassis Board
5.1.
Chassis Installation
1. Stick FELT to SIDE AV BRACKET.
- Stick the SIDE AV INDI. SHEET on the SIDE AV BRACKET.
- Insert the SIDE AV BRACKET from the side position of the A-PCB.
- Insert the SIDE AV BRACKET from the side position of the A-PCB.
TX-LR32S10
11
6 Location of Controls and Components
6.1.
Wire Dressing
1. Wiring No. 1 ~ No.7
2. Remove dust of terminal of LVDS and PB connector. (by ion blow) Pos. A11
3. Insert LVDS into A11.
2. Remove dust of terminal of LVDS and PB connector. (by ion blow) Pos. A11
3. Insert LVDS into A11.
Wire
Clamper
1
2
3
4
5
6
7
8
9
10
11
No.1 A10 ~ V10
No.2 A01 ~ K01
No.3 A12 ~ SP(L)
No.4 A12 ~ SP(R)
No.5 ~ P5
No.6 ~ P6
No.7 A20 ~ P4
TX-LR32S10
12
7 Disassembly and Assembly Instructions
7.1.
AC Cord Dressing
1. Clamp plug with clamper.
2. Insert beads 3pcs. And slide down to lower hole.
2. Insert beads 3pcs. And slide down to lower hole.
Click on the first or last page to see other TX-LR32S10 service manuals if exist.