Panasonic PT-TX301RU / PT-TX301RE / PT-TX301REA / PT-TW331RU / PT-TW331RE / PT-TW331REA (serv.man2) Service Manual ▷ View online
PT-TW331R / PT-TX301R series
5-13
3.Select "Device Manager",then select the
"Ports(COM&LPT)",confirm the Prolific
USB-to-Serial Comm Port.
4.Right click the "Prolific USB-to-Serial Comm
Port",select "Properties"-->"Port Setting",then
select the Bits per second:9600,click "OK".
5.Select "Flash Magic".
PT-TW331R / PT-TX301R series
5-14
6.Choose "ARM Cortex" ,select "LPC113/303"
7.Select the COM Port which is same as
Prolific USB-to-Serial Comm Port.
8.Program settings.
- Select Baud Rate:9600
- Select Interface:None(ISP)
- input the "12.000000"under the
- Select Baud Rate:9600
- Select Interface:None(ISP)
- input the "12.000000"under the
Oscillator(MHZ)
- Select"Erase blocks used by Hex File
- Select"Verify after programming".
PT-TW331R / PT-TX301R series
5-15
9. Click Browse and select the MCU file
where you put the file in.
10.Click “Start”.
11.When NXP MCU upgrade process is
finished, “Finished” will be shown.
PT-TW331R / PT-TX301R series
5-16
MCU-M12 LAN-13H
PT-TW331R-C09 <Aug 30.2013-18:32>
PT-TW331R-C09 <Aug 30.2013-18:32>
Lamp Hour-Full
50
Lamp Hou-Eco
30
Operating Hour
80
Lamp On/Off Counter
11/10
Lamp Voltage/ Max
41 / 41V
UART Response
0 No problems
Over Temp
0
FanLock
0
Lamp Fail
0
CW Fail
0
Spoke Test
✔
Burn in Test
✔
Color Wheel Index
✔
ADC Calibration
✔
SNID
WM2469999
Thermal Detect
Disable
Enable
Waveform ID
0/6/7/8/9/10
Debug Message PJC
On
Off
Direct Power On
On
Off
Factory Fan RPM
4882
Factory Reset
✔
Internal Bus Log
✔
Exit
✔
12. Check MCU FW version.
- Re-plug in power cord and Power on
the projector. Get into the service mode
(Power--Left--Right--Menu) to check
the NXP MCU firmware version.
the NXP MCU firmware version.
Click on the first or last page to see other PT-TX301RU / PT-TX301RE / PT-TX301REA / PT-TW331RU / PT-TW331RE / PT-TW331REA (serv.man2) service manuals if exist.