Panasonic PT-DZ870T / PT-DW830T / PT-DX100T / PT-DZ870U / PT-DZ870E / PT-DW830U / PT-DW830E / PT-DX100U / PT-DX100E (serv.man4) Service Manual ▷ View online
ADJ - 10
5. Select Microprocessor to update, and click [load] button.
DIGITAL LINK software update by LAN terminal connection is not possible.
6. Appoint the microcomputer software that took in a computer beforehand, and click [Open] button.
7. When load of the microcomputer software is completed, a checkmark and path and a version are displayed.
Exclude a checkmark of Microprocessor to fall under, when not updating to the read software.
Without a mistake, click a [Update] button.
Note :
Note :
ADJ - 11
8. Click [OK] button and start update.
While update it, Lamp1-2 indicator indicates as follows.
* Main : Lamp indicator 1-2, alternately flashing red.
* Sub : Lamp indicator all lit green.
* Formatter : Lamp indicator all lit red.
9. If completion and a message are displayed, click [OK] button.
Rewrite the same version of software will be skipped.
10. Click ［EXIT］button, and please be finished.
Reboot Projector, and please confirm whether the version of the Microprocessor Software is updated definitely,
with sub menu " STATUS" of the main menu " PROJECTOR SETUP" .
Note :
Note :
Note :
ADJ - 12
2. 2. Update by the SERIAL terminal connection
2. 2. 1. Equipment to be used
1. Computer : Use it for the transfer of software.
2. Communication cable : D-sub 9pin (male/female RS-232C straight)
3. Service Software : [MainSubNet Update Tool.exe] Service software is downloaded from the projector service homepage.
4. Microprocessor Software: Please download the file from the projector service homepage to the PC.
2. 2. 2. Connection Preparations
* Computer, please set so as not to standby or shutdown.
* Set the "PROJECTOR" in "RS-232C INPUT SELECT"
of "PROJECTOR SETUP" menu.
2. 2. 3. Update procedure
1. Switch the projector to "Normal-Standby" mode (POWER indicator is Lighting in red).
2. Start up service software with a computer, select Model, and then click the [OK] button.
3. Select "Serial" in "Connection", and input the ID, Port, Baudrate, Parity , and click [Connection Check] button.
4. A result of the connection confirmation is displayed.
"Check: OK" ⇒ Click a [OK] button and advance next.
"Check: NG" ⇒ Come back to item 3., and please
confirm whether setting is right.
1. Confirm the projector's ID, baudrate, prity and
take a memo.
take a memo.
2. Connect the "SERIAL IN" terminal of projector
and PC with a RS-232C cable.
and PC with a RS-232C cable.
Notes :
ADJ - 13
5. Select Microprocessor to update, and click [load] button.
6. Appoint the microcomputer software that took in a computer beforehand, and click [Open] button.
7. When load of the microcomputer software is completed, a checkmark and path and a version are displayed.
Exclude a checkmark of Microprocessor to fall under, when not updating to the read software.
Without a mistake, click a [Update] button.
Note :
Click on the first or last page to see other PT-DZ870T / PT-DW830T / PT-DX100T / PT-DZ870U / PT-DZ870E / PT-DW830U / PT-DW830E / PT-DX100U / PT-DX100E (serv.man4) service manuals if exist.