Panasonic PT-AE1000U / PT-AE1000E Service Manual ▷ View online
5.6. Communication Cable Specifications
5.7. Signal Selector Connecting Cable Specifications
When connecting to a signal selector (ex. TW-SWS62J), use a cable with specifications below.
Connecting method: Connects a video signal cable from the signal selector to "VIDEO IN", and an RGB signal cable to "PC IN".
Note:
Set VP control terminal switch of the signal selector to VP TYPE "B".
13
PT-AE1000U / PT-AE1000E
6 Disassembly Instructions
Warning:
·
Be sure to unplug the power cord from the power outlet before disassembling this projector.
Caution:
·
While turning over a printed circuit board, be sure to put a insulating material under it to prevent a short circuit.
·
Printed circuit boards and wires must not be pulled forcibly, but be handled carefully.
·
Connectors also must be handled carefully.
·
When reassembling, replace used adhesive tape with new one (Do not re-use used tape).
·
After repairing this projector, be sure to put back the wires and connectors to the original condition.
·
After disassembling or repairing this projector, do the following confirmation work for LCD panels damage prevention.
1. Disconnect 3 flexible cables of LCD Panels (R/G/B).
2. Turn ON the power and confirm the -6V detection LED (D1031) lights.
(If it does not light, check and repair the -6V circuit.)
3. Turn OFF the power and connect the 3 flexible cables of LCD Panels.
14
PT-AE1000U / PT-AE1000E
6.1. Printed Circuit Board and Main Parts Location
Electrical Parts
Optical Parts
15
PT-AE1000U / PT-AE1000E
6.2. Removal of Upper Case
1. Lift the rear side of the top panel and disconnect the top
panel Open/Close hook, then open the top panel.
2. While pressing hooks of the 2 top panel fastening devices,
remove the top panel.
3. Loosen the 3 screws until they idle.
4. Slide the lamp lock button to release, and remove the lamp
unit block (with lamp unit cover).
5. Unscrew the 8 screws and remove the upper case.
6.3. Removal of A-P.C.Board
1. Remove the upper case according to the section 6.2.
"Removal of Upper Case".
2. Unscrew the 2 screws and remove the A-P.C.Board block.
3. Unscrew the 2 screws and remove the connector cover.
4. Unscrew the 11 screws and remove the A-P.C.Board.
16
PT-AE1000U / PT-AE1000E
Click on the first or last page to see other PT-AE1000U / PT-AE1000E service manuals if exist.