Panasonic UB-5365 / UB-5865 (serv.man2) Service Manual ▷ View online
73
8.2.12. Image Sensor
1. Remove the Image Sensor Module. (See 8.2.11.)
2. Remove the 2 screws (e) on each Image Sensor.
74
8.2.13. Side-back Plate R & Side-back Cover Right
8.2.14. Side-back Cover Left
1. Remove the Cover Right. (See 8.2.4.)
2. Remove the 2 screws (e) to release the Side-back Plate R and
Side-back Cover Right from the Screen Unit.
Side-back Cover Right from the Screen Unit.
1. Remove the Image Sensor Module. (See 8.2.11.)
2. Remove the 2 screws (e) to release the Side-back Cover Left
from the Screen Unit.
from the Screen Unit.
75
8.2.15. Screen (Film)
1. Remove the Side-back Plate R & Side-back Cover Right.
(See 8.2.13.)
(See 8.2.13.)
2. Remove the Side-back Cover Left. (See 8.2.14.)
3. Remove the 2 screws (e), and then remove the Folding Support
(Back).
(Back).
4. Close the Screen Unit properly shown on the figure, so that the
screen tension becomes loose, and lift up the Screen upward to
remove it.
screen tension becomes loose, and lift up the Screen upward to
remove it.
Note:
1. When reassembling a Screen, make sure to check the
Screen with the Home Markers is in the lower part of the
Screen. (When installed upside down, screen scroll
operation is not successful.)
Screen with the Home Markers is in the lower part of the
Screen. (When installed upside down, screen scroll
operation is not successful.)
2. Pay attention to the screen film so that the panel or
plate edges may not give a damage to the film surface.
plate edges may not give a damage to the film surface.
76
8.3.
Printer Unit
(1) Remove the Tray. (See 8.2.1.)
(2) Remove the Thermal Transfer Film. (See 7.2.3-1 and 7.2.3-2.)
(3) Remove the screw (c).
Note:
When installing the Panaboard to the Stand (sold separately),
remove the 4 screws (c).
When mounting the Panaboard on the wall, remove the 2
screws (c).
remove the 4 screws (c).
When mounting the Panaboard on the wall, remove the 2
screws (c).
(4) Disconnect the 2 connectors.
(5) Lift up the Printer Unit slightly in the direction of the arrow (1),
checking the Hooks of the back side shown on the figure are
released from the Board Attachment (Lower), and then pull the
unit in the direction of the arrow (2).
checking the Hooks of the back side shown on the figure are
released from the Board Attachment (Lower), and then pull the
unit in the direction of the arrow (2).
Click on the first or last page to see other UB-5365 / UB-5865 (serv.man2) service manuals if exist.