Panasonic UB-5335 / UB-5835 (serv.man2) Service Manual ▷ View online
49
7.2.5.
Replacing the Thermal Transfer Film
When the remaining copy paper becomes about 15 sheets, the Remaining Film Indicator begins to blink.
When "U => 12 => U => 12 => U..." is displayed on the Display Window, copying is not possible due to lack of Thermal Transfer Film.
In this case, replace the film using the following procedure.
When "U => 12 => U => 12 => U..." is displayed on the Display Window, copying is not possible due to lack of Thermal Transfer Film.
In this case, replace the film using the following procedure.
Note:
• Use the separately sold product (UG-6001) for the Thermal Transfer Film.
(If a film other than this is used, print quality may be affected which results in malfunction.)
• The Thermal Transfer Film is for one-time use only. Dispose the used Thermal Transfer Film as a "plastic product" ac-
cording to the provisions in the region.
• A negative of the copied image will remain on the Thermal Transfer Film. For information protection, cutting the film with
a scissors and the others are recommended at disposal.
• When replacing the Thermal Transfer Film, clean the attached part of the film shaft reception section.
1. Remove the copy paper, push down the Printer Open Lever to open the Printer Door. (See 7.2.3-1.)
2. Pull out the Thermal Transfer Film. (See 7.2.3-2.)
3. Install a new Thermal Transfer Film for replacement. (See 4.7.)
4. Close the Printer Door firmly until it clicks into place. (See 7.2.4-3.)
Note:
If "U => 12 => U => 12 => U..." flashes on the Display Window after closing the Printer Door and turning on the
power, the Thermal Transfer Film is loose or is not correctly positioned.
Make sure that the Thermal Transfer Film has been installed properly and tightened.
power, the Thermal Transfer Film is loose or is not correctly positioned.
Make sure that the Thermal Transfer Film has been installed properly and tightened.
50
7.2.6.
Replacing the Battery
1. Loosen the screw (one location) on the side of the control
panel, and remove the Battery Holder.
2. Remove the old battery, and install a new one with the positive
terminal upward.
Note:
Always use "CR2032" batteries and be sure that the bat-
tery is inserted as indicated on the Battery Holder.
tery is inserted as indicated on the Battery Holder.
3. Set the Battery Holder with the battery side upward and
retighten the screw in step 1.
4. Set the current time. (Refer to the Operating Instructions for
details on setting the current time.)
details on setting the current time.)
51
8 DISASSEMBLY INSTRUCTIONS
8.1.
Disassembly Flowchart
The following flowcharts indicate disassembly sequence for the Exterior, Unit Components, and Circuit Board assemblies.
When reassembling, perform the steps in the reverse order unless otherwise instructed in the Reassembling Notes.
When reassembling, perform the steps in the reverse order unless otherwise instructed in the Reassembling Notes.
Note:
Disassembly flowchart explanation
* This sample flowchart shows that, to disassemble C, the procedures 1 and 2 must be performed first before proceed-
ing to the procedure 3.
ing to the procedure 3.
52
8.1.1.
Screen Block
Click on the first or last page to see other UB-5335 / UB-5835 (serv.man2) service manuals if exist.