Panasonic KV-SS080 Service Manual ▷ View online
25
8.2.9.
Lock / Unlock Selector
8.2.10. CONTROL Board
8.2.11. Motor Assy.
1. Remove the Top Cover Assy. (See 8.2.4.)
2. While releasing the tip of the Lock / Unlock Selector in the
direction of the arrows (1), push the selector in the direction
of the arrow (2) to remove it.
direction of the arrows (1), push the selector in the direction
of the arrow (2) to remove it.
1. Remove the Top Cover Assy. (See 8.2.4.)
2. Remove the 4 screws (e) and disconnect all connectors on the
CONTROL Board.
CONTROL Board.
1. Remove the Top Cover Assy. (See 8.2.4.)
2. Remove the 3 screws (a), 1 screw (a) with washer, and
1 screw (c).
1 screw (c).
3. Disconnect the 1 connector.
26
8.2.12. Tension Plate Assembly
1. Remove the Motor Assy. (See 8.2.11.)
2. Release the Drive Belt from the pulley.
3. Remove the screw (d) and 2 screws (c).
4. Remove the spring to release the Tension Plate Assembly
from the scanner.
from the scanner.
Reassembling Note:
How to assemble the spring
1. Hang one side of the spring to the guide of the
Bottom Cover Assy.
2. Hang the other side of the spring to the guide on
the bottom of plate through the hole of the plate.
1. Hang one side of the spring to the guide of the
Bottom Cover Assy.
2. Hang the other side of the spring to the guide on
the bottom of plate through the hole of the plate.
27
8.2.13. Shaft
8.2.14. Scanning Unit
1. Remove the Motor Assy. (See 8.2.11.)
2. Remove the 2 screws (c).
3. Pull out the Shaft carefully through the hole in the Scanning
Unit in the direction of the arrow to separate the shaft from
the Bottom Cover Assy.
3. Pull out the Shaft carefully through the hole in the Scanning
Unit in the direction of the arrow to separate the shaft from
the Bottom Cover Assy.
1. Remove the Shaft. (See 8.2.13.)
2. Disconnect the connector to the CONTROL Board.
28
8.2.15. Drive Belt
1. Remove the Scanning Unit. (See 8.2.14.)
2. Remove the Drive Belt from the slot of the Scanning Unit.
Note: Adjusting the belt tension
1. Perform the steps in the reverse order in Sec. 8.2.13,
8.2.14, and 8.2.15 to reassemble the Drive Belt,
Scanning Unit, and Shaft.
8.2.14, and 8.2.15 to reassemble the Drive Belt,
Scanning Unit, and Shaft.
2. Reattach the Motor Assy. in the reverse order in
Sec.8.2.11, and then reattach the Drive Belt to the
pulley on the Tension Plate Assembly.
Sec.8.2.11, and then reattach the Drive Belt to the
pulley on the Tension Plate Assembly.
3. Loosen the 2 screws (c) and screw (d) again so that the
belt tension increases on its own.
belt tension increases on its own.
4. Tighten the 2 screws (c) and screw (d).
Click on the first or last page to see other KV-SS080 service manuals if exist.