Panasonic DLS6 Service Manual ▷ View online
Step 2: Turn over the traverse unit, use service jig to turn the
gear counter clockwise.
gear counter clockwise.
Step 3: Once the sub rack is below the guide line, it is ready for
the assembly.
the assembly.
8.4. Disassembling Procedures
8.4.1. Disassembly of traverse unit
Caution:
Do ensure that the traverse unit is in the conditiion to be
disassembled, please refer to section 8.3.1.
disassembled, please refer to section 8.3.1.
Note:
Mechanism unit (DLS6) reliability test must be carry out in
complete unit or using the Reliability P.C.B. (Refer to section
10).
Mechanism unit (DLS6) reliability test must be carry out in
complete unit or using the Reliability P.C.B. (Refer to section
10).
Step 1: Release the guide.
Step 2: Push the traverse slide plate (rib), ensure both grooves
are opened.
Step 2: Push the traverse slide plate (rib), ensure both grooves
are opened.
21
DLS6
Step 3: Release the FFC as arrows shown.
Step 4: Lift the traverse unit up by approximately 45° as shown.
Step 4: Lift the traverse unit up by approximately 45° as shown.
Step 5: Slide out the traverse unit as arrow shown.
Caution:
Ensure the OPU is face upwards, avoid touching the
surface of the traverse unit.
surface of the traverse unit.
22
DLS6
8.4.2. Disassembly of clamp plate unit
" Follow the (Step 1) to (Step 5) of item 8.4.1.
Step 1: Release the catches at both sides of the clamp plate
unit.
Step 2: Slide the clamp plate unit as arrows shown.
unit.
Step 2: Slide the clamp plate unit as arrows shown.
Step 3: Lift up and remove the clamp plate unit as arrow
shown.
shown.
Caution:
Avoid touching the drysurf areas. Below diagram shows the
areas for the drysurf to be applied.
areas for the drysurf to be applied.
23
DLS6
8.4.3. Disassembly of tray
" Follow the (Step 1) to (Step 5) of item 8.4.1.
" Follow the (Step 1) to (Step 3) of item 8.4.2.
" Follow the (Step 1) to (Step 3) of item 8.4.2.
Step 1: Release the guide.
Step 2: Push the traverse slide plate (rib) until it stop.
Step 2: Push the traverse slide plate (rib) until it stop.
Step 3: Slide the tray out fully.
Step 4: Release the catches respectively as arrows shown to
remove the tray.
remove the tray.
Caution:
Avoid touching the drysurf and grease areas. Below
diagram shows the areas of greasing points.
diagram shows the areas of greasing points.
24
DLS6
Click on the first or last page to see other DLS6 service manuals if exist.