Panasonic SD-2510WTS Service Manual ▷ View online
29
6.2.
Body and others
1. Next Bottom side.
2. Remove 3 screws and detach the cord support.
2. Remove 3 screws and detach the cord support.
3. Remove 4 screws for rubber leg fixing, and detach the
rubber legs.
4. Detack the Bottom frame.
5. Remove the glass tape and disconnect the connector for
the power cord assy.
6. Disconnect the connector for Grand wire A assy.
30
6.3.
P.C.Board B assy
1. Remove connector connecting with P.C.Board B.
2. RemoveI faston terminal connecting to P.C.Board B.
2. RemoveI faston terminal connecting to P.C.Board B.
3. Remove the faston terminal connecting to a heater.
*Point around a dismantle
Please headhunt you while pushing a portion of an arrow
for faston terminal with stopper.
Please headhunt you while pushing a portion of an arrow
for faston terminal with stopper.
31
4. Remove three screws which fix a base for P.C.B. to the
main body, and exclude a base for P.C.B..
5. Remove one screw.
Remove a flat cable.
Remove a control board B from a base for P.C.B.
Remove a control board B from a base for P.C.B.
6. Open a claw and exclude P.C.Board A assy from a base
for P.C.B..
32
6.4.
Pulley B, connector lower unit and others
1. Remove six screws and remove heater case unit from the
main body.
2. Next Bottom side.
3. Remove the belt with sliding it out while rotating pulley B.
4. Remove the hexagon nut (special) fixing pulley B by rotat-
3. Remove the belt with sliding it out while rotating pulley B.
4. Remove the hexagon nut (special) fixing pulley B by rotat-
ing it counterclockwise.
5. Remove the round plain washer, lock washer and pulley
B.
6. Remove U-clip and pull the connector lower unit out
toward the inner side.
Tips on assembly
Tips on assembly
• Position each "D" cut of the connector lower unit, pulley
B and lock washer.
Click on the first or last page to see other SD-2510WTS service manuals if exist.