DOWNLOAD Panasonic NC-EG4000WTS / NC-EG3000WTS Service Manual ↓ Size: 3.33 MB | Pages: 26 in PDF or view online for FREE

17

1. Remove 1 holding screw for motorized pump.
2. Remove the communicating bushing from the water pipe

packing A and container comp.

1. Remove water pipe comp.

1. Remove case A comp. after removing 2 screws fixing

case of A comp.

1. Remove the board holder B and control unit B (for display

panel) from upper frame.

2. Remove control unit B (for display panel) removing claws)

of holder B.

3. Pull out the lead wire from E comp.
4. Remove the LED holder.
5. Remove the seal packing F.

• When inserting the lead wire E comp. into the control unit B

(for display panel), insert it toward the direction shown in dia-
gram of the previous figure.

18

1. Remove the screws from the thermal insulator cover.
2. Remove the lead wires from the heater terminals.
3. Remove the thermal insulator cover from the body.
4. Remove the non-flammable tube B.
5. Remove the thermal fuse comp. from the thermal insula-

tor cover.

6. Remove the holding spring A of the thermistor comp. from

the thermal insulator cover.

7. Before removing the thermistor comp. from holding spring

A, turn it 90 degrees.

• Remove the lead wires for thermal fuse comp. with long

nose type pliers.

• Do not mishandle the thermal fuse comp. such as pulling,

bending or twisting.

• In assembling thermistor comp., be careful of gradient.
• In assembling thermistor comp., make sure to apply the

lubricating agent A.

1. Remove the cover comp.
2. Remove the pouring spout.
3. Remove the lock lever A toward upper side by pushing it

while pushing down.

4. Remove the container packing.

19

• When reassembling the pouring spout, insert the dowel of

container comp. into the 2 long ribs. (refer to “Knob” in below
diagram)

• The containner packing shall closely contact the container

flange without twisting or distortion.

1. Remove the name B panel by picking with a bladed

screwdriver or a pin at point “A” .

• Affix name A in the direction of the arrow starting from point

A

1. Remove the bottom ring upward using a bladed screw-

driver or the like.

2. Remove the self-tapping screw.
3. Insert the bladed screwdriver between rib of the peg

frame and rib of the body. Then turn the bladed screw-
driver to the right hand direction and push angle plate
sharply to release it.

• When the body or the bottom ring is replaced, apply a friction

reducing agent. It does not turn smoothly if the volume of the
friction deducing agent is insufficient.

1. Push out transparent portion of water supply and gauge

cover from inside the body with the thumb.

20

1. Remove the 3 screws.
2. Remove the inner lid.

1. Remove the 2 screws.
2. Put a thin bladed screwdriver or the like between the lid

and the lid cover comp., and lever it to separate them.

1. Remove the Lock spring A with longnose plier.

1. Remove the Lock knob B, pressing toward arrow direc-

tion.

2. Pick up the Lock spring B.