Panasonic NC-DG3000WTS Simplified Service Manual ▷ View online
21
Point in reassembling
• Affix name A in the direction of the arrow starting from point
A
6.11. Peg Frame
1. Remove the bottom ring upward using a bladed screw-
driver or the like.
2. Remove the self-tapping screw.
3. Insert the bladed screwdriver between rib of the peg
3. Insert the bladed screwdriver between rib of the peg
frame and rib of the body. Then turn the bladed screw-
driver to the right hand direction and push angle plate
sharply to release it.
driver to the right hand direction and push angle plate
sharply to release it.
Point in reassembling
• When the body or the bottom ring is replaced, apply a friction
reducing agent. It does not turn smoothly if the volume of the
friction deducing agent is insufficient.
friction deducing agent is insufficient.
6.12. Name A
1. Push out transparent portion of water supply and gauge
cover from inside the body with the thumb.
6.13. Lid comp. and Inner Lid
1. Remove 4 screws off.
2. Remove Inner lid off.
2. Remove Inner lid off.
22
6.14. Lid packing and Steam way A
1. Remove steam way A.
2. Remove lid packing.
2. Remove lid packing.
6.15. Lid and Pump comp.
1. Remove 4 screws off.
2. Use minus screwdriver to pry between lid and pump
2. Use minus screwdriver to pry between lid and pump
comp.
6.16. Valve A, Spring B and Seal ring
1. Remove valve A from pump comp.
2. Remove spring B off.
3. Remove seal ring A from valve A.
2. Remove spring B off.
3. Remove seal ring A from valve A.
23
6.17. Shaft
1. Push lover part of pump comp., and push 4 legs of shaft then pull out.
6.18. Lock knob A, Lock spring A
and Lock spring B
1. Catch lock spring A by wrench and pull out.
2. Follow the first section and remove lock Spring B.
3. Remove lock knob B off.
2. Follow the first section and remove lock Spring B.
3. Remove lock knob B off.
6.19. Supporting plate
1. Adjust lock pin of supporting plate at “Release”.
2. Remove supporting plate off.
2. Remove supporting plate off.
Operating point
• When assemble, make sure that caution label is on the cor-
rect position.
24
6.20. Stopper comp.
1. Adjust lock pin of stopper comp. at “Release”.
2. Put minus screwdriver into stopper comp., gap and use power to remove it.
2. Put minus screwdriver into stopper comp., gap and use power to remove it.
Operating point
• After assemble, should to feel to touching of supporting plate on lock knob.
6.21. Shaft assembly
1. Set 4 legs of shaft into groove of pump comp., as picture below.
Click on the first or last page to see other NC-DG3000WTS service manuals if exist.