Panasonic KX-FP88RS-B Service Manual ▷ View online
3.3.5.1. DEFECTIVE FACSIMILE SECTION
3.3.5.1.1. TRANSMIT PROBLEM
CROSS REFERENCE:
LCD MESSAGES(P.3)
MAINTENANCE(P.24)
ADF (Auto Document Feed) SECTION(P.31)
OPERATION PANEL SECTION(P.81)
45
KX-FP88RS-B
3.3.5.1.2. SOMETIME THERE IS A TRANSMIT PROBLEM
Note:
"596: Transmit level set" represents a service code. (Refer to SERVICE FUNCTION TABLE(P.88).)
CROSS REFERENCE:
LCD MESSAGES(P.3)
46
KX-FP88RS-B
3.3.5.1.3. RECEIVE PROBLEM
First confirm whether the recording paper is installed properly or not before starting troubleshooting. (Refer to "Remarks".)
Note:
"596: Transmit level set" represents a service code. (Refer to SERVICE FUNCTION TABLE(P.88).)
Remarks:
Regarding the reception problem, we have investigated the conceivable causes in the flow chart except for the software-related
errors. However, some troubles may occur due to the software-related problems such as "OUT OF PAPER" when the fax
switches to the memory receiving mode and the memory capacity becomes full of the unprintable data. In this case, error
messages [MEMORY FULL] and its main cause, for example "CHECK PAPER" are displayed on the LCD. Once you solve the
main problem, [MEMORY FULL] will be cancelled and the reception problem will be resolved.
errors. However, some troubles may occur due to the software-related problems such as "OUT OF PAPER" when the fax
switches to the memory receiving mode and the memory capacity becomes full of the unprintable data. In this case, error
messages [MEMORY FULL] and its main cause, for example "CHECK PAPER" are displayed on the LCD. Once you solve the
main problem, [MEMORY FULL] will be cancelled and the reception problem will be resolved.
LCD display messages indicating the error causes are shown below.
Refer to LCD MESSAGES(P.3).
CHECK PAPER
COVER OPEN
UNIT OVERHEATED (COVER OPEN, etc.)...Reset the unit.
PAPER JAMMED
CHECK FILM
Please refer to USER RECOVERABLE ERRORS (P.26) for the above items. If it turns out to be a hardware deformity, please
check each sensor. (Refer to TEST FUNCTIONS (P.99).
check each sensor. (Refer to TEST FUNCTIONS (P.99).
47
KX-FP88RS-B
The following two causes can be considered for this symptom.
3.3.5.1.4. THE UNIT CAN COPY, BUT CANNOT TRANSMIT/RECEIVE
CROSS REFERENCE:
ANALOG BOARD SECTION(P.74)
TEST FUNCTIONS(P.99)
3.3.5.1.5. THE UNIT CAN COPY, BUT CANNOT EITHER TRANSMIT/RECEIVE LONG
DISTANCE OR INTERNATIONL COMMUNICATIONS
Cause 1:
The other party is executing automatic dialing, the call has been received by this unit, and the CED or DIS signal response time
is too long. (In most cases, this unit detects the CNG signal and can respond to CED or DIS.) (According to the ITU-T standard,
the communication procedure is cancelled when there is no response from the other party within 35 sec, so that the other party
releases the line.)
is too long. (In most cases, this unit detects the CNG signal and can respond to CED or DIS.) (According to the ITU-T standard,
the communication procedure is cancelled when there is no response from the other party within 35 sec, so that the other party
releases the line.)
48
KX-FP88RS-B
Click on the first or last page to see other KX-FP88RS-B service manuals if exist.