DOWNLOAD Panasonic BB-HCM715CE / BB-HCM735CE Service Manual ↓ Size: 3.52 MB | Pages: 83 in PDF or view online for FREE

41

42

You can reset all of the camera’s settings to their factory default settings.

1. Click the [Maintenance] tab.
2. On the left side of the screen under [Maintenance], click [Reset to Factory Default].

3. Click [Execute].

• The indicator flashes orange, and then turns off for a few seconds.

• Do not turn off the camera while the camera is being reset. When the lens finishes panning and tilting, it is safe to turn off the

camera.

• When the camera is reset, the following information will be deleted:

- All images buffered in the internal memory
- All alarm logs
- All camera settings (including the user name, password, IP address, subnet mask etc.)

The network connection mode changes to [Automatic Setup]. Reconfigure the camera by referring
to the Setup Guide.

• When the camera is reset, the internal clock will not be reset, but the time format will be set to AM/PM mode. 

Change the setting if necessary.

You can also reset all of the camera’s settings to their factory default settings by pressing the FACTORY DEFAULT RESET button
for about one second with a pointed object. The camera must be turned on in order to reset it.

BB-HCM715 only: If the SD card cover (hard type) is attached, remove the cover, then press the FACTORY DEFAULT RESET
button. (see Installation Guide)

43

When you replace the CPU board, you must also attach the new MAC address label (included with the replacement CPU
board). Attach the new MAC address label to the unit by placing over the old MAC address label. Make sure the old address
cannot be seen. Throw away the old CPU board. It cannot be reused.
(IF the MAC address of the old CPU board is already registered via DDNS and then used in a different camera, the camera can-
not be used with DDNS service.)

44

Even if you do not have the special tools (for example, a spot heater) to remove the Flat IC, with some solder (large amount), a
soldering iron and a cutter knife, you can easily remove the ICs that have more than 100 pins.

• PbF (: Pb free) Solder
• Soldering Iron

Tip Temperature of 700

°F ± 20°F (370°C ± 10°C)

Note: We recommend a 30 to 40 Watt soldering iron. An expert may be able to use a 60 to 80 Watt iron where someone with
less experience could overheat and damage the PCB foil.

• Flux

Recommended Flux: Specific Gravity 

→ 0.82.

Type 

→ RMA (lower residue, non-cleaning type)

Note: See About Lead Free Solder (PbF: Pb free) (P.4).

1. Put plenty of solder on the IC pins so that the pins can be completely covered.

If the IC pins are not soldered enough, you may give pressure to the P.C. board when cutting the pins with a cutter.

2. Make a few cuts into the joint (between the IC and its pins) first and then cut off the pins thoroughly.

3. While the solder melts, remove it together with the IC pins.

When you attach a new IC to the board, remove all solder left on the base with some tools like a soldering wire. If some solder
is left at the joint on the board, the new IC will not be attached properly.