DOWNLOAD Panasonic BB-HCM715CE / BB-HCM735CE Service Manual ↓ Size: 3.52 MB | Pages: 83 in PDF or view online for FREE

45

1. Temporarily fix the FLAT PACKAGE IC, soldering the two marked pins.

*Check the accuracy of the IC setting with the corresponding soldering foil.

2. Apply flux to all pins of the FLAT PACKAGE IC.

3. Solder the pins, sliding the soldering iron in the direction of the arrow.

1. Lightly resolder the bridged portion.
2. Remove the remaining solder along the pins using a soldering iron as shown in the figure below.

46

When you replace the CPU board, you must also attach the new MAC address label (included with the replacement CPU
board). Attach the new MAC address label to the unit by placing over the old MAC address label. Make sure the old address
cannot be seen. Throw away the old CPU board. It cannot be reused.
(IF the MAC address of the old CPU board is already registered via DDNS and then used in a different camera, the camera can-
not be used with DDNS service.) Refer to How to Change MAC Address Label (P.43).

1. Remove four Screws (A).
2. Remove Cabinet Cover.

3. Remove two Screws (B), four Cables and CPU Board.

47

• 1, 2 are the same as 8.1.1. How To Remove CPU Board (P.46).

3. Remove four Screws (B).
4. Remove Cabinet Body.

5. Remove four Screws (B) and two Cables, and remove I/O Board and
PoE Board.

48

• 1, 2 are the same as 8.1.1. How To Remove CPU Board (P.46).
• 3, 4 are the same as 8.1.2. How To Remove I/O Board and PoE Board (P.47).

6. Remove two Screws (B) and Cable, and remove Eye Block.

7. Remove two Spacers, Pan Gear and Pan Cap from Eye Block.

8. Remove four Screws (B).
9. Delete solder of Cable and remove Tilt Motor Unit.