DOWNLOAD Panasonic BB-HCM580CE (serv.man2) Service Manual ↓ Size: 4 MB | Pages: 96 in PDF or view online for FREE

41

You can reset all of the camera’s settings to their factory default settings.

1.  Click the [Maintenance] tab.
2.  On the left side of the screen under [Maintenance], click [Reset to Factory Default].

3. Click [Execute].

• The indicator flashes orange, and then turns off for a few seconds.

• Do not turn off the camera while the camera is being reset. When the lens finishes panning and tilting, it is safe to turn off the

camera.

• When the camera is reset, the following information will be deleted:

- All images buffered in the internal memory
- All alarm logs
- All camera settings (including the user name, password, IP address, subnet mask etc.)

The network connection mode changes to [Automatic Setup]. Reconfigure the camera by referring to the Setup Guide.

•  When the camera is reset, the internal clock will not be reset, but the time format will be set to AM/PM mode. Change the setting

if necessary

• See Operating Instructions for a list of the camera’s default settings.

You can also reset all of the camera’s settings to their factory default settings by pressing the FACTORY DEFAULT RESET button
for about one second with a pointed object. The camera must be turned on in order to reset it.

42

When you replace the CPU board, you must also attach the new MAC address label(included with the CPU board). Attach the
new MAC address label to the unit by placing over the old MAC address label. Make sure the old address cannot be seen.
Throw away the old main board. It cannot be reused.
(IF the MAC address of the old CPU board is already registered via DDNS and thenused in a different camera, the camera can-
not be used with DDNS service.)

43

• PbF (: Pb free) Solder
• Soldering Iron

Tip Temperature of 700

°F ± 20°F (370°C ± 10°C)

Note: We recommend a 30 to 40 Watt soldering iron. An
expert may be able to use a 60 to 80 Watt iron where some-
one with less experience could overheat and damage the
PCB foil.

• Flux

Recommended Flux: Specific Gravity 

→ 0.82.

Type 

→ RMA (lower residue, non-cleaning type)

Note: See About Lead Free Solder (PbF: Pb free) (P.3).

1. Tack the flat pack IC to the PCB by temporarily soldering

two diagonally opposite pins in the correct positions on
the PCB.

Be certain each pin is located over the correct pad on the PCB.

2. Apply flux to all of the pins on the IC.

3. Being careful to not unsolder the tack points, slide the sol-

dering iron along the tips of the pins while feeding enough
solder to the tip so that it flows under the pins as they are
heated.

1. Add a small amount of solder to the bridged pins.
2. With a hot iron, use a sweeping motion along the flat part

of the pin to draw the solder from between the adjacent
pads.

44

When you replace the CPU board, you must also attach the new MAC address label(included with the CPU board). Attach the
new MAC address label to the unit by placing over the old MAC address label. Make sure the old address cannot be seen.
Throw away the old CPU board. It cannot be reused.
(IF the MAC address of the old main board is already registered via DDNS and thenused in a different camera, the camera can-
not be used with DDNS service.)

1. Remove three Screws (C). And remove the Cabinet Cover.

2. Remove the Screw (B). And remove the I/O Board.