Panasonic SB-WA500EB / SB-WA500EE / SB-WA500EG / SB-WA500GN / SB-WA500GS / SB-WA500PH Service Manual ▷ View online
13
7.3.
Disassembly of Side Panel Unit
Step 1 : Peel off the screw covers by using the pen knife.
Caution : Place it in original location during assembling.
Caution : Place it in original location during assembling.
Step 2 : Remove 4 screws.
Step 3 : Insert the flathead screwdriver into the gap of the Side
Panel Unit.
Step 4 : Lift up the Side Panel Unit slightly.
Panel Unit.
Step 4 : Lift up the Side Panel Unit slightly.
Step 5 : Insert two flathead screwdriver at the gap and apply
force to gently push out the Side Panel Unit as shown.
Caution : Do not exert too much force as it may damage
the Side Panel Unit.
force to gently push out the Side Panel Unit as shown.
Caution : Do not exert too much force as it may damage
the Side Panel Unit.
14
Step 6 : Lift up the Side Panel Unit by 30° as shown.
Step 7 : Slide out the Side Panel Unit as arrow shown.
Step 7 : Slide out the Side Panel Unit as arrow shown.
Caution : During assembly of the Side Panel Unit, align the
bosses to their respective holes on the Speaker Cabinet
Assembly and attach it.
bosses to their respective holes on the Speaker Cabinet
Assembly and attach it.
7.4.
Disassembly of Passive Radia-
tor
tor
• Refer to “Disassembly of Side Panel Unit”.
Step 1 : Remove 8 screws.
Step 2 : Lift up and remove Passive Radiator as arrow shown.
15
7.5.
Disassembly of Woofer
Speaker (SP61)
Speaker (SP61)
• Refer to “Disassembly of Side Panel Unit”.
• Refer to “Disassembly of Passive Radiator”.
• Refer to “Disassembly of Passive Radiator”.
Step 1 : Remove 4 screws.
Step 2 : Detach the black (+) and red (-) speaker wire.
Step 3 : Remove Woofer Speaker (SP61) as arrow shown.
Step 3 : Remove Woofer Speaker (SP61) as arrow shown.
16
7.6.
Disassembly of Amp Module
Assembly
Assembly
Step 1 : Remove 1 screw.
Step 2 : Remove 6 screws.
Step 3 : Lift down slightly the Amp Module Assembly as arrow
shown.
Caution : Do not exert too much force as it may damage
the wiring within.
Step 4 : Detach the 2P Wire of the connector (CN1005) on D-
Amp P.C.B..
Step 5 : Detach the 5P Cable Wire of the connector (CN1003)
on D-Amp P.C.B..
Step 6 : Remove the Amp Module Assembly as arrow shown.
shown.
Caution : Do not exert too much force as it may damage
the wiring within.
Step 4 : Detach the 2P Wire of the connector (CN1005) on D-
Amp P.C.B..
Step 5 : Detach the 5P Cable Wire of the connector (CN1003)
on D-Amp P.C.B..
Step 6 : Remove the Amp Module Assembly as arrow shown.
Click on the first or last page to see other SB-WA500EB / SB-WA500EE / SB-WA500EG / SB-WA500GN / SB-WA500GS / SB-WA500PH service manuals if exist.