Panasonic SA-VK870EE / SC-VK870EE Service Manual ▷ View online
8.4.6. Deck Mechanism Error Code Table
8.5. Sales Demonstration Lock Function
This function prevents discs from being lost when the unit is used for sales demonstrations by disabling the disc eject function.
“LOCKED” is displayed on the unit, and ordinary operation is disabled.
“LOCKED” is displayed on the unit, and ordinary operation is disabled.
8.5.1. Setting
•
•
•
•
Prohibiting removal of disc
1. Select the DVD/CD function.
2. At POWER ON condition, press and hold down the
button and the power button on the main unit for at least three
seconds. (The message, “LOCKED” appears when the function is activated.)
Note:
OPEN/CLOSE
button is invalid and the main unit displays “LOCKED” while the lock function mode is entered.
•
•
•
•
Prohibiting operation of selector and disc
1. Select the DVD/CD function.
2. At POWER ON condition, press and hold down the
button and the power button on the main unit for at least three
seconds. (The message, “LOCKED” appears when the function is activated.)
Note:
The following buttons are invalid and the main unit displays “LOCKED” while the lock function mode is entered.
Main unit
OPEN/CLOSE,
/-TUNE MODE/—FM MODE, SELECTOR,
/
/
,
/
/
Remote
controller unit
iPod/USB, FM/EXT-IN, NUMERIC KEYS 0~9,
,
,
,
,
,
,
, RETURN,
FUNCTIONS, FL DISPLAY/SLEEP, MUTING
8.5.2. Cancellation
The lock can be cancelled by the same procedure as used in setting. (“UNLOCKED” is displayed on cancellation. Disconnecting
the power cable from power outlet does not cancel the lock.)
the power cable from power outlet does not cancel the lock.)
8.6. Service Precautions
8.6.1. Recovery after the DVD player is repaired
•
•
•
•
When the FLASH ROM IC or DVD Module P.C.B. is replaced, carry out the recovery processing to optimize the drive.
Playback the recovery disk to process the recovery automatically.
•
•
•
•
Recovery disc (Product number: RFKZD03R005) [SPG]
•
•
•
•
Performing recovery process
1. Load the recovery disc RFKZD03R005 on to the player and run it.
2. Recovery is performed automatically. When it is finished, a message appears on the screen.
3. Remove the recovery disc.
37
SA-VK870EE
4. Turn off the power.
5. Initialize the player.
8.6.2. Firmware version-up of the DVD player
•
•
•
•
The firmware of the DVD player may be renewed to improve the quality including operability and playability to the substandard
discs.processing to optimize the drive.
discs.processing to optimize the drive.
The recovery disc has also firmware version-up.
•
•
•
•
After version-up, recovery processing is executed automatically.
•
•
•
•
Part number of the recovery disc for version-up will be noticed when it is supplied.
•
•
•
•
Updating firmware
1. Load the recovery disc on to the player and run it.
2. Firmware version of the player is automatically checked. Appropriate message appears whenever necessary.
3. Using remote controller´s cursor key, select whether version updating is to be done or not. (Selection of Yes/No)
4. a. If Yes is selected, version updating is performed.
b. If No is selected, only recovery is performed.
5. a. When updating is finished, remove the disc according to the message appearing on the screen.
b. Remove the disc according to the message appearing on the screen.
6. Turn off the power.
Note:
If the AC power supply is shut out during version-up due to a power failure, the version-up is improperly carried out.
In such a case, replace the FLASH ROM IC and carry out the version-up again.
8.6.3. DVD Module P.C.B. Reset
•
•
•
•
When after replacing FLASH ROM IC or DVD Module P.C.B., FL displays error code “DVD F897”. This means the unit is not
initialized properly and the following process needs to be carry out.
initialized properly and the following process needs to be carry out.
•
•
•
•
Procedures:
1. Press
on remote control while pressing “STOP” button on main unit. (To enter into initialization)
2. FL display show “INIT”
3. While still pressing “STOP” button on main unit, press “OK” on remote control. (To reset the unit)
4. FL will display “RESET” before FL display will change to TOC reading again.
5. Power off unit. Unplug the AC cord.
6. Power on the unit. It should be no problem. If problem persist check on the DVD Module P.C.B. or FLASH ROM IC.
38
SA-VK870EE
9.1. Caution
Below is the list of disassembly sections
Below shown is part no. of different screws types used:
9 Assembling and Disassembling
“Attention Servicer”
Some chassis components may have sharp edges. Be careful when disassembling and servicing.
1. This section describes procedures for checking the operation of the major printed circuit boards and replacing the main
components.
2. For reassembly after operation checks or replacement, reverse the respective procedures.
Special reassembly procedures are described only when required.
3. Select items from the following index when checks or replacement are required.
4. Refer to the Parts No. on the page of “Replacement Parts List” (Section 25), if necessary.
5. This model uses CR14 Mechanism unit. This section includes disassembly & assembly procedures for traverse unit only. For
more information on the operation of CR14 mechanism, refer original service manual (Order No. MD0801004CE).
Caution:
After replacing of Mechanism Unit (CR14), ageing test is necessary. Please confirm operation for Mechanism Unit (CR14).
•
•
•
•
Disassembly of Top Cabinet
•
•
•
•
Disassembly of Mechanism Unit (CR14)
•
•
•
•
Disassembly of Rear Panel
•
•
•
•
Disassembly of Front Panel Unit
•
•
•
•
Disassembly of Panel P.C.B., Tact Switch P.C.B., Remote Sensor P.C.B., Side Bar (L/R) LED P.C.B.
•
•
•
•
Disassembly of Mic P.C.B.
•
•
•
•
Disassembly of USB P.C.B.
•
•
•
•
Disassembly of Music Port P.C.B.
•
•
•
•
Disassembly of CD Lid
•
•
•
•
Disassembly of Deck Mechanism Unit
•
•
•
•
Disassembly of Deck P.C.B.
•
•
•
•
Disassembly of Deck Mechanism
•
•
•
•
Disassembly of Deck Mechanism P.C.B.
•
•
•
•
Disassembly of Cassette Lid
•
•
•
•
Rectification for Tape Jam Problem
•
•
•
•
Disassembly of D-Amp P.C.B.
•
•
•
•
Replacement of Audio Digital Power Amp IC (IC5000)
•
•
•
•
Replacement of Audio Digital Power Amp IC (IC5200)
•
•
•
•
Replacement of Audio Digital Power Amp IC (IC5300)
•
•
•
•
Replacement of Audio Digital Power Amp IC (IC5400)
•
•
•
•
Disassembly of Main P.C.B.
•
•
•
•
Disassembly of SMPS P.C.B.
•
•
•
•
Replacement for Switch Regulator IC (IC5701)
•
•
•
•
Replacement for Switch Regulator Diode (D5702)
•
•
•
•
Replacement for Regulator Diode (D5801)
•
•
•
•
Replacement for Regulator Diode (D5802)
•
•
•
•
Replacement for Regulator Diode (D5803)
•
•
•
•
Disassembly of AC Inlet P.C.B.
•
•
•
•
Disassembly of DVD Module P.C.B.
39
SA-VK870EE
40
SA-VK870EE
Click on the first or last page to see other SA-VK870EE / SC-VK870EE service manuals if exist.