Panasonic CW-C72KD / CW-C92KD Service Manual ▷ View online
8
.3.5. Slide the Chassis out from the
Cabinet.
9
8.3.3. Remove the Front Grille.
a. Remove the adhesive tapes from all sides of the Front
Grille.
b. Open the Control Panel cover.
c. At the bottom right side of the Front Grille, press inward on
the Cabinet near the Power Cord and pull the grille outward
to the right until the right tab releases.
to the right until the right tab releases.
d. At the bottom left side, push inward on the Cabinet and pull
the grille outward to the left to release the left tab. Do not
pull the bottom edge toward you more than 3 inches as to
prevent top two tabs from damage.
pull the bottom edge toward you more than 3 inches as to
prevent top two tabs from damage.
e. Slide the Front Grille upward to free the two top tabs from
slots at the top of the Cabinet.
8.3.2. Remove the Air Filter.
•
•
•
•
Tilt up and pull out the air filter by the holder.
8.3.4. Remove the Chassis Locking
Brackets from the Cabinet.
•
•
•
•
Unscrew and remove both Chassis Locking Brackets. Keep
them for reinstallation.
them for reinstallation.
8.3.1. Remove the Front Intake Grille.
1. Push
on
the indication.
Front
Intake
Grille will be
automatically released.
2. Pull up the Front Intake Grille to about 90°. Slide it slightly
to the left to unhook the tabs.
8.3. Installation Procedure.
8
.3.7. Slide the Chassis back into the
Cabinet.
8
.3.8. Lock the Chassis back to the
Cabinet by using back the Chassis
Locking Brackets.
Locking Brackets.
8
.3.10. Insert the Air Filter.
10
8.3.6. Place Cabinet into the installation
hole, then secure it by wood
screws or nails.
screws or nails.
•
•
•
•
Note: Tilt down for better drainage (max. 10mm).
8.3.9. Reattach the Front Grille to the
Cabinet and secure it with screws.
•
•
•
•
Note: Depending upon the location of the AC outlet, route
the AC cord to either the left or right side while installing the
Front Grille.
the AC cord to either the left or right side while installing the
Front Grille.
8.3.11. Reattach the Front Intake Grille.
•
•
•
•
Slide the Front Intake Grille slightly to the right to reattach
the tabs and then push down to close tight.
the tabs and then push down to close tight.
Note: A”Click” sound can be heard when the Front Intake
Grille is pushed down.
Grille is pushed down.
Note: Drain hose or tubing can be purchased locally to satisfy
your particular needs.
your particular needs.
This air conditioner employs a “Slinger-Up System” which is
designed to splash the condensed water on the condenser coil
for maximum cooling efficiency, thus producing a splashing
sound. If the splashing sound annoys you, you can provide an
outside drainage by using the following procedure which may,
however, cause a small loss of performance.
1. Slide out the Chassis from the Cabinet.
2. Remove the rubber plug from the Base Pan.
3. Install the Drain Pan at the right corner of the Cabinet with
designed to splash the condensed water on the condenser coil
for maximum cooling efficiency, thus producing a splashing
sound. If the splashing sound annoys you, you can provide an
outside drainage by using the following procedure which may,
however, cause a small loss of performance.
1. Slide out the Chassis from the Cabinet.
2. Remove the rubber plug from the Base Pan.
3. Install the Drain Pan at the right corner of the Cabinet with
2 screws.
4. Connect the drain hose to the outlet of Drain Pan bottom.
5. Slide the Chassis back into the Cabinet.
5. Slide the Chassis back into the Cabinet.
9.1. Cleaning the Unit.
Clean the Cabinet, Front Grille with a mild soap or detergent
and lukewarm water.
and lukewarm water.
9.2. Cleaning the Front Intake
Grille.
Gently wash with water and a sponge. (Do not use a scrubbing
brush or other hard cleaning aids).
brush or other hard cleaning aids).
the stopper.
3. Tilt up and pull out the Air Filter by the holder.
4. Vacuum the front of the filter and then wash the back of it
4. Vacuum the front of the filter and then wash the back of it
with water. If it is badly soiled, wash with a mild household
detergent.
detergent.
8.4. Condensed Water Drainage.
9 Care and Maintenance
Caution: Always turn off the air conditioner and the main power supply before unplugging the power cord to clean the
unit.
Note: Do not clean with benzene, thinner, scouring powder or corrosive chemicals. Do not dry the Front Intake Grille or
the Air Filter in direct sunlight. Exposure to direct sunlight may discolor or deform the panel.
the Air Filter in direct sunlight. Exposure to direct sunlight may discolor or deform the panel.
11
9.3. Cleaning the Air Filter.
1. Push and release the bottom of the Front Intake Grille.
2. Lift up the Front Intake Grille at 45° until it is supported by
the stopper.
1. Remove the Front Intake Grille (refer to page 9).
2. Remove the Air Filter (refer to page 9).
3. Remove the Front Grille (refer to page 9).
4. Remove the 2 knobs.
5. Take off the Control Panel.
6. Release the sensor thermostat from the holder sensor.
7. Loosen the 2 screws of the Control Board.
8. Slide the Control Board out from the chassis.
•
•
•
•
Control Board Part Location.
10 Service Information
10.1. Removal of the Control Board
12
Click on the first or last page to see other CW-C72KD / CW-C92KD service manuals if exist.