LG WT-W7111TH Service Manual ▷ View online
8
3-5. Turbo Clean Filter
Net for catching lints.
Turbo clean filter
9
4. PARTS IDENTIFICATION
Water supply hose
Function selector
Pulsator
Powder detergent ( powder bleach )box
for delayed washing
for delayed washing
Softener box
Power On/Off Button
Lint filter
Washing Tub Fully
stainles steel tub
Start/Pause Button
Use to start or stop the
washing machine tem-
porarily.
washing machine tem-
porarily.
Anti Rat Base
Drain hose
Check if the drain hose
is located in the laundry
tub before operating the
washing machine.
is located in the laundry
tub before operating the
washing machine.
Drain hose
Power plug
If the supply cord is
damaged, it must be
replaced by the manufacture
or its service agents or
similarly qualified person
in order to avoid a hazard.
damaged, it must be
replaced by the manufacture
or its service agents or
similarly qualified person
in order to avoid a hazard.
Inlet hose
Drain hose
1 Each for cold and
hot water
Accessories
10
5. INSTALLATION INSTRUCTION
A. HOW TO INSTALL THE WASHING MACHINE
How to use the adjusting plates
¡⁄
Use the adjusting plates to level the washer
when the adjustable legs cannot cover the gap.
when the adjustable legs cannot cover the gap.
1
2
Adjustable leg
Turn the adjustable legs to set the washer
horizontal (2 EA).
horizontal (2 EA).
Installation area
¡⁄
Install the washer on flat and firm
surface.
Improper installation of the washer may cause noise and malfunctioning.
1. The ventilating openings in the base area must not be obstructed be carpeting
when the washing machine is installed on a carpeted floor.
2. Install the washing machine on a level and firm surface, any tilt should be
less than 1
¡
¡˘
˘
.
!
Checking level
¡⁄
Open the lid, and check if the washer is
correctly leveled by looking down from
the top.
the top.
11
More than 10cm
More than 2cm
More than 2cm
3
5
4
Horizontal setting
¡⁄
Lift up the front of the washer and
adjust level by turning the adjustable
legs clockwise or using the adjusting
plate.
legs clockwise or using the adjusting
plate.
Confirming level
Distance between drain hose and the wall
Checking slope
¡⁄
If installation surface is tilted, the
washer will be shaken.
washer will be shaken.
¡⁄
Place the washer to original position
and confirm the level.
¡⁄
Distance between drain hose and the wall
should be more than 10 cm, and the distance
between the other part and the wall should be
more than 2 cm.
should be more than 10 cm, and the distance
between the other part and the wall should be
more than 2 cm.
Click on the first or last page to see other WT-W7111TH service manuals if exist.