LG WM1375HW Service Manual ▷ View online
28
Disassemble the clamp assembly.
Unscrew the 2 screws from cabinet cover.
Open the filter cover and unscrew 1 screw.
Remove the lower cover.
Unscrew all the screws from upper and lower
part of the cabinet cover.
Disassemble the clamp assembly.
When reassembling the gasket, put the drain
hole of the gasket downward.
GASKET ASSEMBLY
29
Disassemble the back cover.
Remove the belt.
Remove the nut.
Pull out the pulley.
Unscrew 2 screws from the bracket.
Disassemble the motor in arrow direction.
When reassembling the motor, make sure that motor
mounting bushings are not taken off from the bracket.
Disassemble the damper hinges from the tub and
base.
Separate the dampers.
Hinge,
Damper
Damper
Damper
1
2
3
PULLEY, MOTOR, DAMPER
(PULLEY)
(MOTOR)
(DAMPER)
Clean the drain pump filter
NOTE
Once removed, replace the damper pin with new
one.
one.
1. Open the lower cover
cap
( ) with a tool
such as coin.
Turn the drain plug
( ) to pull out the
hose.
Turn the drain plug
( ) to pull out the
hose.
2. Unplug the drain plug
( ), allowing the water
to flow out. At this time use a vessel to prevent
water from flowing
onto the floor. When water does not flow any
more, turn the pump filter
water from flowing
onto the floor. When water does not flow any
more, turn the pump filter
( ) open to the left.
3. Remove any foreign objects from the
pump filter
( ). After cleaning, turn the
pump filter
( ) clockwise and insert the
drain plug
( ) to the original place.
Close the lower cover cap
( ).
• Allow the water to cool down before cleaning the drain pump filter.
① Disassemble the cabinet cover.
② Separate the pump hose and the bellows from
the pump assembly.
③ Disassemble the pump assembly in arrow
direction.
① Disassemble the back cover.
② Separate 2 connectors from the heater.
③ Loosen the nut and pull out the heater.
① Disassemble the back cover.
② Unplug the white connector from the
thermistor.
③ Pull it out by holding the bracket of the
thermistor.
Washing
Heater
Heater
Nut
Ring Terminal
PUMP
HEATER
THERMISTOR
30
• When assembling the heater, insert the heater
into the heater clip on the bottom of the tub.
• Tighten the fastening nut so the heater is
secure.
!
① Open the door and disassemble the Clamp
assembly.
② Unscrew the 2 screws.
③ Disconnect the connector from the Door
switch assembly.
① Disassemble the back cover.
② Separate the heater from the tub.
③ Remove any foreign objects (wire, coin, etc.)
by inserting a long bar in the opening.
WHEN A FOREIGN OBJECT IS STUCK BETWEEN DRUM AND TUB
31
NOTE
Reconnect the connector after replacing the
DOOR SWITCH ASSEMBLY.
DOOR SWITCH ASSEMBLY.
SWITCH ASSEMBLY, DOOR LOCK
Click on the first or last page to see other WM1375HW service manuals if exist.