LG WM1375HW Service Manual ▷ View online
24
NO
YES
YES
YES
NO
NO
NO
YES
3
1
2
(1) (2)
S P I N T R O U B L E
Check the SENSOR SWITCH
ASSEMBLY or HOSE (Pressure).
If the problem is on the SENSOR
SWITCH ASSEMBLY or the
HOSE, replace the SENSOR
SWITCH ASSEMBLY or the
HOSE.
ASSEMBLY or HOSE (Pressure).
If the problem is on the SENSOR
SWITCH ASSEMBLY or the
HOSE, replace the SENSOR
SWITCH ASSEMBLY or the
HOSE.
Normal
Reconnect or repair
connector
connector
Replace the MOTOR
ASSEMBLY
ASSEMBLY
Check during spin if the frequency of the water
level is 248 or more.
level is 248 or more.
Press the Start/Pause button 2 times in QC
Test mode, is the drum spinning at low speed?
Test mode, is the drum spinning at low speed?
Is it disconnected, or disassembled?
[Red:3pin(1), White:6pin(2)]
[Red:3pin(1), White:6pin(2)]
Check the motor connector, is the resistance of
the terminal same as the figure?
MOTOR TERMINAL (1)
Resistance of terminal:
About 6.5Ω
Replace the MAIN PWB ASSEMBLY
Does the spring of Latch Hook actuate?
Is DOOR SWITCH ASSEMBLY broken?
Replace the DOOR SWITCH ASSEMBLY.
Replace Door Assembly.
Check the DOOR SWITCH
ASSEMBLY Connector and
MAIN PWB ASSEMBLY
ASSEMBLY Connector and
MAIN PWB ASSEMBLY
9. DISASSEMBLY INSTRUCTIONS
Be sure to unplug the machine from the outlet before disassembling and repairing the parts.
① Unscrew 2 screws on the back of the top plate.
② Pull the top plate backward and upward as
shown.
③ Disconnect the Display PWB Assembly
connector from Flat cable.
④ Pull out the drawer and unscrew 2 screws.
⑤ Push 2 upper hooks and pull the Control Panel
Assembly forward.
⑥ Unscrew the 6 screws from the Control Panel
Assembly.
⑦ Disassemble the Display PWB Assembly.
25
Hook
CONTROL PANEL
PLATE ASSEMBLY (TOP)
PANEL ASSEMBLY
(CONTROL)
(CONTROL)
PWB
ASSEMBLY
(DISPLAY)
ASSEMBLY
(DISPLAY)
26
① Disassemble the Top plate assembly.
② Pull out the drawer.
③ Unscrew the 2 screws and push out the
dispenser assembly.
④ Disassemble the clamps and hoses.
⑤ Disassemble the bellows at the lower side of
the dispenser.
DISPENSER ASSEMBLY
DISPENSER ASSEMBLY
DRAWER
27
① Disassemble the 4 connectors from the valves.
② Unscrew the 2 screws from the back of the
cabinet.
Wire color
VALVE
(MAIN WASH)
WH - BK
VALVE
(BLEACH)
RD - BK
VALVE
(HOT)
BL - BK
① Open the door.
② Unscrew the 2 screws from the Cabinet Cover.
③ Disassemble the door upward.
※ When removing the Door Assembly, it is
necessary to hold the Bracket that is inside of
the Cabinet Cover.
the Cabinet Cover.
Drain in to bucket by pulling out hose and
removing cap.
removing cap.
Method of removing remaining water
CAP (REMAINING HOSE)
1
2
3
INLET VALVE
LOWER COVER
DOOR
Click on the first or last page to see other WM1375HW service manuals if exist.