LG WD-14376FDM Service Manual ▷ View online
25
9. DISASSEMBLY INSTRUCTIONS
Disassemble and repair the parts after pulling out power cord from the outlet.
CONTROL PANEL
1
Unscrew the screws on the top plate.
2
The plate assembly(Top) is pulled back and
then upward to arrow direction.
3
The cover(Inner) is disassembled.
1
Pull out the drawer and unscrew 2 screws.
2
Lift the side the Control Panel Assembly and
pull it out.
1
Two screws are unscrewed.
2
Push out PANEL ASSEMBLY, CONTROL
after Push the hook( , ) below.
1
2
1
The PWB assembly(Display) is disconnected.
2
When 7 screws are unscrewed on the PWB
insulator and the PWB assembly(Display) is
disassembled from the PWB insulator.
1
3
2
PLATE ASSEMBLY(TOP)
DRAWER PANEL ASSEMBLY
PANEL ASSEMBLY, CONTROL
PWB ASSEMBLY
(DISPLAY)
(DISPLAY)
26
PWB ASSEMBLY(MAIN)
1
The cabinet cover is removed.
2
Two screw are unscrewed.
3
Pull the PWB assembly(Main) to arrow direction.
4
One screws is unscrewed.
5
The cover of PWB assembly(Main) is removed.
6
Disconnect connector from the wiring.
DISPENSER ASSEMBLY
1
The plate assembly(Top) are disassembled.
2
Pull the drawer to arrow direction.
1
The hose clamps and the hose are
disassembled.
2
The ventilation bellows are disassembled on
the tub.
3
Two screws are unscrewed.
DRAWER
27
INLET VALVE
1
Disconnect the wiring connector.
2
Remove the valve by two screws of the valve
holder.
When reconnecting the connector
DOOR
Removing method of remained water
1
Open the door completely.
2
Remove the two screws from the hinge.
※
When removing the Door Assembly, it is
necessary to hold the Bracket that is inner
of the Cabinet Cover.
necessary to hold the Bracket that is inner
of the Cabinet Cover.
※
First, prepare a bucket to put in the
remained water.
remained water.
VALVE (STEAM)
VALVE (PRE-WASH)
VALVE (NORMAL-WASH)
VALVE (HOT)
VIOLET/BLACK-BLACK
WHITE/BLACK-BLACK
GRAY/BLACK
BLACK/WHITE
1
2
3
4
Pull it out from hose.
CAP (REMAINING HOSE)
28
CABINET COVER
1
Unscrew the 2 screws from the lower of the
DECO PANEL.
1
Two screws are unscrewed.
2
Push out PANEL ASSEMBLY, CONTROL after
Push the hook( , ) below.
1
2
1
Unscrew the 2 screws from upper of the
cabinet cover.
1
Put a flat ( - ) screwdriver or putty knife into the
both sides of the pump case, and pull it out.
1
Unscrew the screw from the lower side of the
cabinet cover.
2
Unscrew the screw from the pump case.
1
3
2
PANEL ASSEMBLY, CONTROL
PUMP CASE
Click on the first or last page to see other WD-14376FDM service manuals if exist.