DOWNLOAD LG WD-10130NT / WD-10131NNU Service Manual ↓ Size: 1.78 MB | Pages: 34 in PDF or view online for FREE

3. PARTS IDENTIFICATION

Spanner

Cotton

Synthetic

Delicate

Wool

Hand Wash

Quick 30

Rinse+Spin

Rinse Hold

No Spin

400

800

1000

Cold

30

40

60

95˚C

Time Save

Pre Wash

Crease Free

Rinse+

Pump

Spin

Temp.

Option

ACCESSORIES

Before servicing ask the customer what the trouble is.
Check the adjustment (power supply is 220-240V, remove the transit bolts....)
Check the troubles referring to the troubleshooting.
Decide service steps referring to disassembly  instructions.
Then, service and repair.
After servicing, operate the appliance to see whether it works O K or NOT.

STANDARD INSTALLATION

The appliance should be installed as follows.

REMOVE THE TRANSIT 

INSTALL THE  APPLIANCE

ADJUST THE 

BOLTS

ON FLAT AND FIRM SURFACE

HORIZONTAL

Remove the transit bolts

Turn the adjustable feet to

(4EA: ) with supplied wrench. 

set the appliance horizontally.

Keep the transit bolts and  

wrench for future use.

Insert the 4 caps provided 

into the hole.

The appliance goes up by 

rotating the feet clockwise. 

The appliance comes down by

rotating the feet counter-

clockwise.

4. INSTALLATION 

1

HOW TO CONNECT INLET HOSE

Check that the rubber washer is inside of the

valve connector.

Connect the inlet hose firmly to prevent leak.

CONNECT DRAIN HOSE

CONNECT POWER PLUG

Make sure that the hose is not twisted.

The drain hose should be placed under 100cm from the floor.

Connect the power plug to the wall outlet.

Avoid connecting several electric devices, 

It may be the cause of a fire.

Avoid submerging the end of the hose.

TEST OPERATION

Connect the power plug to

In case of cotton program.      

the outlet.

Connect the inlet hose.   

Preparation for 

Press the power button.

Press the START/PAUSE

washing.

button.

Check if the drum rotates  

Check if water is supplied

clockwise and  counterclockwise.  

through the detergent dispenser.

Power off and  then power on.
Check if the door can be 
opened after 2 minutes.

Press the Start/Pause button
after selecting Pump button by
pressing Program button.

If SVC is needed during 

check, remove

the remaining water by pulling 

out the hose cap.

Check the water heating.

Check automatic reverse

Check the water supply.

turn.

Check drain and spin 

Power off and open the 

Water removal 

door